Xerox 4850 NPS, 4090 NPS, 4890 NPS, 4050 NPS manual Loss of some supply voltage to XER

Models: 4050 NPS 4850 NPS 4090 NPS 4890 NPS

1 248
Download 248 pages 10.85 Kb
Page 98
Image 98

PRINTER CONTROLLER MESSAGES

Message

 

Explanation/action

J146

MIR self test input failure.

There has been an MIR board failure or some input signal

 

 

line is shorted to ground.

 

 

No action required.

 

 

If problem persists, notify your service representative.

J147

MIR self test output

There has been an MIR board failure or an off-board

 

failure.

problem in the PHR output device or the signal line.

 

 

No action required.

 

 

If problem persists, write down the message and call your

 

 

service representative.

J148

XER self test output

There has been an XER board failure, an off-board

 

failure.

problem in some XER output device or signal line, or loss

 

 

of +15V to the XER board.

 

 

No action required.

 

 

If problem persists, notify your service representative.

J149

XER self test A/D failure.

The failure may be caused by a XER board failure, an off

 

 

board problem affecting analog outputs such as ñ15V, or

 

 

a loss of some supply voltage to XER.

 

 

No action required.

 

 

If problem persists, notify your service representative.

J155

BFR self test input failure.

There is a BFR board failure.

 

 

No action required.

 

 

If the problem persists, notify your service representative.

J156

BFR self test output

There is a BFR board failure.

 

failure.

No action required.

 

 

 

 

If the problem persists, notify your service representative.

J165

Stacker cover opened in

The stacker cover is open.

 

print.

Remove the paper and close the doors.

 

 

J169

FOR self test input failure.

There is an FOR board failure.

 

 

No action required.

 

 

If problem persists, notify your service representative.

J170

FOR self test output

There is an FOR board failure.

 

failure.

No action required.

 

 

 

 

If problem persists, notify your service representative.

J176

Stacker offset fault.

The stacker did not offset as specified; the mechanism

may be defective. No action required.

If problem persists, notify your service representative.

48-34

XEROX DOCUPRINT 4050/4090/4850/4890/92C NPS MESSAGES GUIDE

Page 98
Image 98
Xerox 4850 NPS, 4090 NPS, 4890 NPS, 4050 NPS manual Loss of some supply voltage to XER