Xerox a2 manual 1 2 3 4 5 6 7, Sample timeout setting screen

3

4

5

6

Perform one of the following:

•Use the up and down arrows (Figure 55) to increase or decrease the desired time before returning to the default settings after a job is complete or only partially programmed, entering Low Power mode, powering off, or exiting System Administration mode. Be sure

to stay within the stated minimum and	Figure 55: Sample timeout setting screen
maximum times.

•Touch the Timeout Disabled button to prevent the machine from timing out.

NOTE: The disable option is not available on the Low Power Timeout or Auto Power Off screen. If the copier/printer is not used for over four hours (default setting), it must enter Low Power mode.

To re-enable an option that was previously disabled, use the up arrow to set a new time.

Touch Close to display the Timeouts screen.

If necessary, repeat steps 2 through 4 for other timeout settings.

Touch Close to display the Tools screen.

1

2

3

4

5

6

7

DOCUCOLOR 12 SYSTEM ADMINISTRATION GUIDE 3–37 TOOLS MODE