Yamaha 01X Noise is produced., Sound recorded via the digital input sounds grainy., Signal from the INPUT 8 jack is too loud., Not all tracks will record/play back., Cant save to a library., Cant reproduce a scene., The volume of a particular channel increases or decreases., Level does not change even when moving the fader.

Before UsingBasics SectionAppendix Getting StartedReference

01X Owner’s Manual 145

Troubleshooting

■Noise is produced.

• Is the latency setting of the mLAN Driver appropriate?.........“mLAN Driver Setup”, “ASIO mLAN Control Panel” (Installation Guide)

•(For Windows) In the BIOS settings, set Hyper Threading to off.

• Is the wordclock setting correct for both

the 01X and the external device(s)?................................................... page 92, “Settings by mLAN Auto Connector” (Installation Guide)

• Is an unsynchronized signal being input?..........................................................................................................................................page 92

• Is the dither setting appropriate?....................................................................................................................................................... page 93

• The oscillator may be functioning.....................................................................................................................................................page 93

• If the speed of your computer’s hard disk is slow, problems may occur during recording and playback.

• If you connect/disconnect the LAN, USB or the cables to the mini jacks terminals on the Macintosh you are using when using mLAN,

some noise may be caused and/or data may be cut off. Make sure that you do not insert or unplug ant connections when using mLAN.

• Is the number of audio channels appropriate?

The amount of audio channels that can be used simultaneously

differs depending on the computer capacity and speed...................... page 92, “Settings by mLAN Auto Connector” (Installation Guide)

• Is the sampling rate (wordclock) appropriate?

A high sampling rate can be the cause of

the noise depending on the computer capacity and speed.................. page 92, “Settings by mLAN Auto Connector” (Installation Guide)

• Are there any noise-producing devices (such as those containing power inverters, etc.) near the cables?

Move all cables away from any possible noise sources.

• Is the mLAN cable damaged? Old cables and thin cables can be the cause of noise.

Make sure to use the included mLAN cable or any other high-quality cable with the same thickness.

• When using the mLAN driver, make sure to turn off or disable any background applications (for example, virus scanning software or

auto backup routines). Otherwise, noise may result due to instability of the driver operation. When not using the mLAN driver (it can

be set to OFF from mLAN Manager), you can turn on or enable the above-mentioned software again.

■Sound recorded via the digital input sounds grainy.

• Is the dither setting appropriate?....................................................................................................................................................... page 93

■Signal from the INPUT 8 jack is too loud.

•A conventional line-level signal may be connected to the Hi-Z jack................................................................................................page 21

■Not all tracks will record/play back.

• Is the number of channels for mLAN audio receiving/sending (set on the mLAN Auto Connector) appropriate?..........Installation Guide

■Can’t save to a library.

• Is the scene library protected?........................................................................................................................................................... page 86

• It is not possible to save to the factory-preset libraries..................................................................................................................... page 36

■Can’t reproduce a scene.

• One or more channels may be set to Recall Safe.............................................................................................................................. page 86

■The volume of a particular channel increases or decreases.

• Are the dynamics processor settings appropriate?.................................................................................................................pages 100, 122

• Automation (Automix) may have been recorded.............................................................................................................................. page 15

■Level does not change even when moving the fader.

•Have the appropriate mode and layer been selected?.................................................................................................................pages 37, 40

• Make sure the fader is not set to PRE FADER in the AUX settings...............................................................................................page 100

• Has the FLIP function been turned on?.............................................................................................................................................page 19

• Make sure that the signal routing of the audio is not set to PRE FADER or PRE EQ in the direct out conﬁguration.....................page 91