94
Function Tree/Function List
01X Owner’s Manual
Before Using Basics Section AppendixGetting Started Reference
MIDI [UTILITY] → Channel knob 6
1 STUDIO MANAGER ID
u1 – 8 Determines the Studio Manager ID. This number must match the Console
Device ID of the Studio Manager (page 9) when transferring the data. No
2 MIDI CHANNEL
t
TX CH
(Transmit Channel)
1 – 16
Determines the MIDI Transmit channel for transmitting MIDI (program
change) messages. No 87
y
RX CH
(Receive Channel)
1 – 16
Determines the MIDI Receive channel for receiving MIDI (program change)
messages. No 87
3PROGRAM CHANGE
bTX ON/OFF
(Transmit On/Off)
Enables (ON) or disables (OFF) transmission of Program Change messages
from the 01X. (Also see “Program Change Assign Table” below.) No 87
nRX ON/OFF
(Receive On/Off)
Enables (ON) or disables (OFF) reception of Program Change messages on
the 01X from an external device. (Also see “Program Change Assign Table”
below.)
No 87
mOMNI ON/OFF Determines whether program change messages are received over all MIDI
channels or not. (Also see “Program Change Assign Table” below.) No 87
4PROGRAM CHANGE ASSIGN TABLE
w
PGM (Program Change
Number)
1 – 128
This determines the assignment of program change number to Scene number.
In other words, it allows you to specify which MIDI program change number
(sent via an external device) selects which Scene on the 01X. When a Scene is
recalled on the 01X, the Program Change number assigned to that Scene is
transmitted. Program change messages are sent and received over mLAN Port
5.
•Make sure to set the SHIFT + REMOTE function to “NO ASSIGN” when
transmitting/receiving program change data.
•Scenes 01 – 99 are assigned by default to program change numbers 1 – 99
in order, and Scene 00 (initial setting) is assigned to program change num-
ber 100.
• These program change/Scene number assignments can be stored to exter-
nal devices (such as a computer) by using the included Studio Manager
software.
• When the same Scene is assigned to more than one program change num-
ber, the lowest program change number takes precedence.
No 87
r
SCENE
(Scene Number)
NO ASSIGN/00 – 99
No 87
,INIT (Initialize) Initializes or resets the Scene/Program Change assignments to their default
values. Yes
Knob Function name/
settings Explanation Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [ / ]