01X Owner’s Manual
Mixing Tutorial
63
Before UsingBasics SectionAppendix Getting StartedReference
Routing audio to specific mLAN outputs
You can use the following operation to send audio buses to
specific mLAN output pairs. For example, you can direct
the two Aux Out pairs (AUX 1/2, AUX 3/4) to separate
mLAN outputs. You can route the stereo bus and the
record bus (REC Bus) to independent mLAN outputs from
this page as well. Keep in mind, this all happens digitally
over the high-speed IEEE 1394 (Firewire/i.Link) connec-
tion, letting you directly feed digital audio to an mLAN-
equipped device. For more information about mLAN and
related applications, see page 22 and the separate Installa-
tion Guide.
■Operation
qMake sure your computer (mLAN device) is properly
connected to the 01X and configured for operation.
For details on using mLAN, see page 66 and the sepa-
rate Installation Guide.
wCall up the Utility mode by pressing the [UTILITY]
button.
ePress knob 2 to call up the Patch parameters.
rSelect page 5 with the DISPLAY [ / ] (Up/Down)
buttons.
Page 5 contains four Output Patch sources: Stereo Bus,
Recording Bus, Aux Bus 1/2, and Aux Bus 3/4.
tUse the even numbered knobs to change the mLAN
output channel pair for each audio bus.
For example, to send the Aux 1/2 signals to mLAN
channels 9 and 10, turn knob 6 until “9/10” is selected
for the Aux 1/2 settting.
If desired, save this setting also to the Output Patch
Library for future recall. (See page 91.)
Storing your custom patch setups
Once you create a Patch setup, you’ll probably want to
save it for future use. That’s what the Input and Output
Patch Libraries are for. They let you store your custom
Input and Output settings, so that the next time you have a
same or similar recording situation, you can appropriately
reconfigure the entire console with just a few button
presses.
■Operation
qCall up the Utility mode by pressing the [UTILITY]
button.
wPress knob 2 to call up the Patch parameters.
eUse the DISPLAY [ / ] (Up/Down) buttons to select
the Library page.
The Input Patch Library is on Page 4, while the Output
Patch Library is on Page 8.
rUse knob 1 to select the desired Library preset number.
tPress STORE (knob 6) followed by YES (knob 8) to
save the settings to the selected number.
yName your new Library preset.
For details on naming, see page 41.
UTILITY OUTPUT PATCH (mLAN OUT CHANNEL) 5/8
ST-BUS≥[1/2 ] RECBUS≥[3/4 ] AUX1/2≥[5/6 ] AUX3/4≥[7/8 ]
Stereo
Bus
mLAN destination pair
Recording
Bus
Aux Bus
3/4
Aux Bus
1/2
UTILITY OUTPUT PATCH (mLAN OUT CHANNEL) 5/8
ST-BUS≥[1/2 ] RECBUS≥[3/4 ] AUX1/2≥[9/10] AUX3/4≥[7/8 ]
UTILITY INPUT PATCH LIBRARY 4/8
*00[Initial Data ] RECALL/STORE /CLEAR