01X Owner’s Manual
Mixing Tutorial
57
Before UsingBasics SectionAppendix Getting StartedReference
1) Effect send routingThe 01X features four separate effect send routings: AUX
1, AUX 2, AUX 3 and AUX 4. AUX 1 and 2 are used only
for external routing (to your favorite outboard effects, for
example). AUX 3 and 4 are used for the two internal effect
blocks, and those are the ones we’ll cover here.
Here, you’ll route Effect 1 to the AUX 3 bus and set an
appropriate level for the effect.
• If 88.2kHz/96kHz operation (page 92) is enabled, only one internal
effect block is available (Effect 1/Aux 3).
■Operation
qPress the [EFFECT] button.
The button toggles between EFFECT 1 and EFFECT 2.
Select EFFECT 1 here (press DISPLAY [ ] (Up) but-
ton if necessary).
wMake sure that Patch is set to AUX 3, Bypass is off (--),
and Mix is set to 100%.
These are the default settings for Effect 1 (Effect 2 is
set to AUX 4), so you may not need to change them.
2) Effect type and parametersThe Reverb Hall type is selected by default. There are sev-
eral other reverb types among the presets; you may want to
explore these as well.
■Operation
qCall up the Effect 1 Library page.
From the Effect display pages (press [EFFECT] if nec-
essary), use the DISPLAY [ / ] (Up/Down) buttons
to call up Effect 1 Library.
Using the DISPLAY [ / ] (Up/Down) buttons
• This is the last page of the Effect 1 pages, and you’ll probably
have to press the DISPLAY [ ] (Down) button five times to get
there. You can also hold down [PAGE SHIFT] and press the DIS-
PLAY [ ] (Down) button to jump through the ‘top’ pages in each
group—in which case, you can get to the Library page in two
DISPLAY [ ] (Down) button presses.
wSelect the desired effect type.
Use knob 1 to select the type, then press RECALL
(knob 5) followed by YES (knob 8) to actually call it
up. There are 43 different preset effect types (see the
list on page 125). There’s also memory space in the
Library for 85 of your own custom settings (page 36).
EFFECT1 PATCH BYPASS MIX TYPE[REVERB HALL ]
AUX3 -- 100%
Bypass
Turns the effect sound on or off. (Remem-
ber that Bypass ON means the effect sound
is off; to hear the effect sound, use the “--”
setting.) Use this to listen to the mix with or
without the effect.
EFFECT1 PATCH BYPASS MIX TYPE[REVERB HALL ]
AUX3 -- 100%
Patch
This determines where the
sound of Effect 1 will be sent
in the mix. Although this is
normally set to AUX 3, you
can also use it as a channel
insert effect (directly insert-
ing the effect to a single
channel, before the EQ and
Dynamics processing), or
directly to the stereo buses.
Mix
This determines the amount of the
effect in the mix. Generally, this
should be set at or near 100%.
You can control how much effect
each channel has with the channel
send level below.
EFFECT1 LIBRARY TYPE[REVERB HALL ]
*01[Reverb Hall ] RECALL/STORE /CLEAR