Yamaha 01X Factory Set (Restore Factory Defaults)

Basic Operations

01X Owner’s Manual

Before Using Basics Section AppendixGetting Started Reference

rEnter the letters, numbers, or symbols by turning the

channel knob [5].

tTurn any of the channel knobs [2] - [4] to move the cur-

sor to the position of the next character.

yEnter the other characters, by repeating steps r - t

above.

uAfter entering the characters, press channel knob

[8](OK) to execute the operation.

•Never attempt to turn off the power while data is being writ-

ten to Flash ROM (while an “EXECUTING BACKUP. PLEASE

KEEP POWER ON...” message is shown). Turning the power

off in this state results in loss of all user data and may cause

the system to freeze (due to corruption of data in the Flash

ROM).

Factory Set (Restore Factory Defaults)

This let you restore the 01X’s default settings. Once you

edit any settings, the corresponding factory defaults will be

overwritten and lost. Use the procedure below to restore

the factory default settings.

•When you restore the factory default settings, all the settings for

the all the Libraries and Utility will be overwritten with the fac-

tory defaults. Make sure you are not overwriting any important

data. You should backup any important data to your computer

beforehand by using Studio Manager. (For more details on using

Studio Manager, see page 47 and the Studio Manager PDF man-

ual.)

qTurn the power of the 01X off. Then, while holding

down the [SCENE] and [UTILITY] buttons, turn the

power back on. The display prompts you for conﬁrma-

tion.

•To cancel the operation, press channel knob [8] (NO).

wPress channel knob [7] (YES) to execute the operation.

•Never attempt to turn off the power while data is being writ-

ten to Flash ROM (while an “Initializing backup data, please

keep power on...” message is shown). Turning the power off

in this state results in loss of all user data and may cause

the system to freeze (due to corruption of data in the Flash

ROM).

Insertion/Deletion of Characters

Channel knob [6] is assigned to Insertion (INSERT)

and Deletion (DELETE). Turn the channel knob [6]

to select the Insertion (INSERT) or Deletion

(DELETE) function.

To insert/delete a particular character, move the

cursor to the desired position (in steps e and t

above) and press channel knob [6]. Note that the

DELETE operation does not delete the character

before the cursor, but the ﬂashing character on the

cursor.

SCENE LIBRARY SCENE No. [ 05]

05 [Initial Eata ] CHAR INSERT EXIT/OK

Do you want to initialize backup data? YES NO