92
Function Tree/Function List
01X Owner’s Manual
Before Using Basics Section AppendixGetting Started Reference
nSTORE
An Output Patch is stored to internal memory in the Output Patch Library. Up
to 32 Output Patches can be stored. The confirmation prompt can be turned
on/off as desired. (See “Store Confirmation” on page 95.)
•Any and all data in the Store destination will be lost when executing the
Store operation. Make sure to save and archive important data to com-
puter using the Studio Manager program (page 9).
Yes 65
mCLEAR This deletes the selected Output Patch. Yes
W.CLK (Wordclock) [UTILITY] → Channel knob 3
1 mLAN AUTO W.CLK (mLAN Auto Wordclock)
zENABLE
When “ENABLE” is selected, the 01X automatically switches its wordclock
status to master or slave, depending on the setting of the connected computer.
The current status is shown at the top right of the display. The indication
“**kHz” is shown when the system is “unlocked” (no signal present). When
the 01X is set to “master” (either automatically or manually), use the next
page, W.CLK SELECT, to specify the wordclock setting. When the 01X is set
to “slave,” the wordclock is set automatically to “mLAN.”
• When mLAN is used, make sure to set this to “ENABLE.” Select the
wordclock (sample rate) with the Auto Connector application. (Refer to
the separate Installation Guide.)
Yes
23
xDISABLE Yes
2W.CLK SELECT (Wordclock Select)
z
INTERNAL
(Internal clock)
• Changing the wordclock settings on any of the devices in your digital
audio system may produce noise in some of the devices For this rea-
son,make sure to turn down the level of your amp/speaker system to
avoid damage to your speakers (and ears).
With this setting, the 01X uses its own internal clock. Press the appropriate
knob (below) to enter the display for selecting the desired sampling frequency.
If you set this to “INT96kHz/88.2kHz” when the current layer is 17 – 24
(mLAN), layer 1 – 8 is automatically called up and channel 1 becomes the cur-
rently selected channel. These settings are not available when wordclock is set
to “EXT-mLAN.”
No 23
z INT44.1kHz
c INT48kHz
b INT88.2kHz
m INT96kHz
Determines the frequency of the wordclock (sampling rate). Yes
c
EXT-D.IN
(External clock:
digital in)
With this setting, the 01X is used as the wordclock master (page 23) by syn-
chronizing to the signal received via STEREO DIGITAL IN. This setting is
not available when wordclock is set to “EXT-mLAN.” The following indica-
tions may appear in the display.
EXT-D.IN:Can be used.
xEXT-D.IN:System is “unlocked” (no signal present). Cannot be selected.
*EXT-D.IN:Cannot be synchronized because of some error (phase differ-
ence, etc.)
Yes 23
bEXT-mLAN
(External clock: mLAN)
This is for display purposes only and cannot be changed.
EXT-mLAN:This (external mLAN) is the currently-selected wordclock
source.
xEXT-mLAN:System is “unlocked” (no signal present).
*EXT-mLAN:Cannot be synchronized because of some error (phase dif-
ference, etc.)
No 23
Knob Function name/
settings Explanation Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [ / ]