96
Function Tree/Function List
01X Owner’s Manual
Before Using Basics Section AppendixGetting Started Reference
4 SOLO MODE
u / iMIX SOLO/
LAST SOLO
When using the Solo function with the [ON] button ([SOLO] button is on),
this determines whether multiple channels can be soloed (MIX SOLO) or only
the last selected channel is soloed (LAST SOLO).
No
5 SOLO SAFE
z – ,ENABLE
Input Channels can be configured individually so that they are not muted when
other Input Channels are soloed (Solo Safe function). Signals from Input
Channels that are set to ENABLE are always fed to the Stereo bus, regardless
of the channels’ Solo function status.
No
MON (Monitor) [UTILITY] → Channel knob 8
1 MONITOR (Monitor Mix Balance)
r
A (LED-ON)
“INT>0: 126<DAW” –
“INT>126: 0<DAW”
The audio signals of the last two available channels (the last two numbered
channels specified with mLAN Auto Connector; refer to the separate Installa-
tion Guide) from the DAW which are input to the 01X mLAN channels 17/18
(or 9/10 when set to 96kHz/88.2kHz operation) are output directly to the mon-
itor/headphones output without processing. The settings here let you set the
output balance between the DAW audio and the audio of the 01X itself, and let
you switch between two of these assignments using the [MONITOR] button
—Monitor A (the lamp lights) or Monitor B (the lamp is off). These settings
can also be made by holding the [MONITOR] button and turning the knob [5]
(for A) or [7] (for B).
INT> 0: 126<DAW.....100% DAW audio (no audio from internal mixer)
INT>126: 0<DAW.....100% internal mixer audio (no audio from DAW)
• Pressing the knob sets the balance to 50%-50%
•To restore the default setting (shown above), simultaneously hold down
[SHIFT] and press the corresponding knob.
No 37 @7
y
B (LED-OFF)
“INT>0: 126<DAW” –
“INT>126: 0<DAW”
PAGE [INTERNAL] → ([SELECTED CHANNEL] → [SEL]) → [EQ] / [PAN] / [SEND] / [DYNAMICS] / [GROUP] / [EFFECT]
EQ LOW [INTERNAL] → ([SELECTED CHANNEL]) → [EQ LOW]
EQ LOW GAIN/EQL-G
q – i
(y)-18.0dB – +18.0dB
Adjusts the gain level. When Q is set to HPF, this turns the filter on or off.
Pressing the [EQ LOW] and [EQ HIGH] buttons simultaneously resets all
band parameters (gain, frequency and Q) for the selected channel.
No
EQ LOW FREQUENCY/EQL-F
q – i
(t)21.2Hz – 20.0kHz Adjusts the frequency. No
EQ LOW Q/EQL-Q
q – i
(r)
HPF, 10.0 – 0.10,
L.SHELF
Determines the bandwidth of the EQ processing. When Q is set to HPF, the
gain control turns the filter on or off. No
Knob Function name/
settings Explanation Prompt
Related
pages
Block
diagram
[PAGE SHIFT] + DISPLAY [ / ]
[PAGE SHIFT] + DISPLAY [ / ]