24
Setting Up
01X Owner’s Manual
Before Using Basics Section AppendixGetting Started Reference
Setting Up
Make sure that the 01X’s [STANDBY/ON] switch is set to
the STANDBY (off) position.
qConnect one end of the AC cable to the PA-300.
wConnect the PA-300’s DC plug to the 01X’s DC IN ter-
minal on the rear panel.
eConnect the other end (normal AC plug) to the nearest
electrical outlet.
•When unplugging the AC Adaptor, disconnect it in reverse order from
that above.
• Do not attempt to use an AC adaptor other than the Yamaha PA-
300 or an equivalent recommended by Yamaha. The use of an
incompatible adaptor may cause irreparable damage to the 01X,
and may even pose a serious shock hazard! ALWAYS UNPLUG
THE AC ADAPTOR FROM THE AC POWER OUTLET WHEN THE
01X IS NOT IN USE.
• Even when the switch is in the “STANDBY” position, electricity
is still flowing to the instrument at a minimum level. When not
using the 01X for an extended period of time, be sure to unplug
the AC power adaptor from the wall AC outlet.
Once you’ve made all the necessary connections (page 23)
between your 01X and any other devices, make sure that
all volume settings are turned down all the way to zero,
then turn on the every device in your setup in the order of
MIDI masters (senders), MIDI slaves (receivers), then
audio equipment (mixers, amplifiers, speakers, etc.). This
ensures smooth signal flow from the first device to the last
(first MIDI, then audio).
• Before beginning installation of mLAN Driver for Windows, switch off
the power to the 01X (see the separate Installation Guide).
• When powering down the setup, first turn down the volume for each
audio device, then switch off each device in the reverse order (audio
devices first, then MIDI).
• Be sure to restar t your DAW after restarting the 01X (turning the
power off and on again) or switching the DAW in the Remote Select
menu (page 87). (This applies when using SQ01, Cubase/Nuendo or
Digital Performer.)
• Before you switch your 01X on or off, turn down the volume of
any connected audio equipment.
qPress the [STANDBY/ON] switch.
A splash screen is displayed. The
Internal mode (Home) screen
appears next.
wRaise the sound system volume to a
reasonable level.
eTurn the 01X’s MONITOR/
PHONES knob clockwise to set an
appropriate volume level.

Power Supply

Power-on Procedure

Rear Panel
PA-300
w DC IN
q
AC cable
To electrical
outlet
e

Turning on the 01X

POWER
ON!!