136 Automation

Digital Recording Console 02R User’s Guide
Fader Edit
The third AUTOMIX display function is the Fader Edit screen shown
below:
The top half of the display shows the current fader positions graphically
for the input channels (MIC/LINE 1 through 16, LINE 17/18 through
23/24), the tape and effect return channels (TAPE 1 through 16, EFF1 and
EFF2), and the stereo output. There is also the “MOTOR ON” icon.
The bottom of the display consists of two rows. The first row allows you
set the Fader Edit Out RETURN and time, and select the Fader Edit Mode
(ABSOLUTE or RELATIVE).
The last row contains the automation transport control icons (AUTOREC,
REC, PLAY, STOP, or ABORT).

MOTOR ON

When you select this icon (the icon is in reverse video and the text reads
MOTOR OFF), the fader motors are switched off during playback of an
automix. The fader levels will still change according to the recording, but
the faders will not move.

Fader Edit Out

You can control how the faders will return to the previously recorded
values when you perform an overdub. If you select RETURN, when the
02R plays back the overdub, it will return the fader to the location
previously recorded in the data. You can set a value between 0.0 and 3.0
seconds over which the fader will change levels.
If you do not select RETURN, the fader will remain in the last position
until the next recorded movement.
1. Press the [AUTOMIX]
button.
An AUTOMIX display
function appears.
Press the [AUTOMIX ]
button repeatedly to get
to the “Fader Edit”
screen.
2. Use the CURSOR buttons
to select the MOTOR ON
icon and press [ENTER] to
change its value.
3. Select the “Fader Edit
Out” RETURN check box
with the CURSOR buttons
and press the [ENTER]
button. Rotate the
encoder wheel to set a
“Time” value.
4. Select the desired
“Fader Edit Mode”
check box with the
CURSOR buttons and
press the [ENTER] button.
5. Use the CURSOR buttons
and the [ENTER] button to
operate the automation
transport.
AUTOMIX