2 Install the rear panels (left and right).

 

1 Attach two short screws (6 ⋅

 

 

14mm) to each edge of the

10mm

 

rear panel (center) using

 

 

your fingers so that the

 

 

screw threads project about

 

 

10mm from the surface.

 

 

Make sure that the screws

 

 

will not loosen and fall out

 

 

of the holes.

 

 

2 Make sure that the screws you finger-tightened

 

in Step 1 have not loosened. Then position the

ENGLISH

handhold of the rear (left) panel toward the

that the bracket does not scratch the rear panel

 

rear, and hook the bracket of the rear (left)

panel onto the projecting screws as shown in the illustration 2. When doing so, be careful

(center).

3Align the holes located under the handhold on

the rear panel (left) with the holes on the main unit, then tighten two long screws (6 ⋅ 45mm)

to secure the panel to the unit.

4Lightly tighten two short screws (6 ⋅ 14mm) into the bracket on the bottom of the unit to secure the panel to the unit.

2

3

 

 

Position the bracket

4

to the rear of the

 

rear panel (left).

5Follow the same steps to install the rear panel (right).

3 Fasten the rear panels securely.

Tighten the screws securely in the order shown in the illustration. Be careful not to permit mis- aligned levels on the front surface, or a gap on the top surface of rear panels (center, left, and right).

1

1

Edges must

 

 

be flush.

2

2

 

3

3

Do not allow

 

 

a gap.

60CLP-F01Keyboard Stand Assembly

4 Attach the fall-prevention bracket.

Align the second and fourth holes on the fall-pre- vention bracket with the bracket holes on the bot- tom of the unit, then secure the bracket using two short screws (6 ⋅ 14mm).

5 Set the voltage selector and connect the power cord.

1Insert the AC power cord plug into the AC INLET connector on the rear of the unit.

2Attach the cord holders in the locations along the path of the power cord on the rear panel, then clip the cord into the holders.

Cord holders

Voltage Selector

Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a “minus” screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the AC INLET and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area.

WARNING

An improper voltage setting can cause serious damage to the Clavinova or result in improper operation.

Page 60
Image 60
Yamaha CLP-F01 owner manual Voltage Selector, Install the rear panels left and right, Fasten the rear panels securely