Recording Your Performance to MIDI

Re-Recording a Specific Section — Punch In/ Out (REC MODE)

When re-recording a specific section of an already-recorded Song, use the Punch IN/OUT function. In this method, only the data between the Punch In point and the Punch Out point is overwritten with the newly recorded data. Keep in mind that the notes before and after the Punch In/Out points are not recorded over, although you will hear them play back normally to guide you in the Punch In/Out timing. You can specify the Punch In and Punch Out points as measure numbers beforehand for automatic operation, or manually execute the Punch In/Out recording by using a Foot Pedal or simply by playing the keyboard.

The explanations here apply to the REC MODE display in step 4 of the “Basic Editing Operation” on page 158.

1 Use the [1π†]–[6π†] buttons to determine the settings for rerecording (see below).

2 While holding the SONG [REC] button, press the desired track but- ton.

3 Press the SONG [F/K] (PLAY/PAUSE) button to start playback.

Play the keyboard at the Punch In point and stop recording at the Punch Out point.

4 Press the [I] (SAVE) button to call up the Song Selection display for saving your data, then save the data in the Song Selection display (page 67).

■PUNCH IN settings

NORMAL

Overwrite recording starts when pressing the SONG [F/K]

 

(PLAY/PAUSE) button or when you play the keyboard in the

 

Synchro Standby mode.

 

 

FIRST KEY ON

The Song plays back normally, then starts overwrite recording as

 

soon as you play the keyboard.

 

 

PUNCH IN AT

The Song plays back normally up to the beginning of the indi-

 

cated Punch In measure, then starts overwrite recording at that

 

point. You can set the Punch In measure by pressing the [3π†]

 

button.

 

 

■PUNCH OUT settings

REPLACE ALL

This deletes all data after the point at which recording is stopped.

 

 

PUNCH OUT

The Song position at which recording is stopped is regarded as

 

the Punch Out point. This setting maintains all data after the

 

point at which recording is stopped.

 

 

PUNCH OUT AT

Actual overwrite recording continues until the beginning of the

 

specified Punch Out measure (set with the corresponding display

 

button), at which point recording stops and normal playback

 

continues. This setting maintains all data after the point at which

 

recording is stopped. You can set the Punch Out measure by

 

pressing the [6π†] buttons.

 

 

CAUTION

The recorded Song data will be lost if you select another Song or turn the power to the instrument off without executing the Save operation (page 67).

Songs Editing and Creating Using,

PSR-OR700 Owner’s Manual 159