Using, Creating and Editing Voices

Voice Creating — Voice Set

VOLUME/ATTACK

VOL

Adjusts the overall volume of the Organ Flutes. The longer the

 

graphic bar, the greater the volume.

 

 

RESP

Affects both the attack and release (page 94) portion of the sound,

 

increasing or decreasing the response time of the initial swell and

 

release, based on the FOOTAGE controls. The higher the value, the

 

slower the swell and release.

 

 

VIBRATO SPEED

Determines the speed of the vibrato effect controlled by the Vibrato

 

On/Off and Vibrato Depth on the previous page.

 

 

MODE

The MODE control selects between two modes: FIRST and EACH.

 

In the FIRST mode, attack is applied only to the first notes played

 

and held simultaneously; while the first notes are held, any subse-

 

quently played notes have no attack applied. In the EACH mode,

 

attack is applied equally to all notes.

 

 

4', 2 2/3', 2'

These determine the attack sound volume of the ORGAN FLUTE

 

Voice. The 4', 2-2/3' and 2' controls increase or reduce the volume

 

of attack sound at the corresponding footages. The longer the

 

graphic bar, the greater the attack sound volume.

 

 

LENG

Affects the attack portion of the sound producing a longer or shorter

 

decay immediately after the initial attack. The longer the graphic

 

bar, the longer the decay.

 

 

EFFECT/EQ

Same parameters as in the VOICE SET “EFFECT/EQ” tab display explained on page 95.

Disabling automatic selection of Voice Sets (effects, etc.)

Each Voice is linked to its related parameter settings that are indicated in the VOICE SET displays, including effects and EQ. Usually these settings are automatically called up when a Voice is selected. However, you can also disable this feature by the operation in the relevant display as explained below.

For example, if you want to change the Voice yet keep the same Harmony effect, set the HARMONY/ECHO parameter to OFF (in the display explained below).

You can set these independently by keyboard part and parameter group.

1Call up the operation display.

[FUNCTION] → [E] REGIST.SEQUENCE/FREEZE/VOICE SET → TAB [√][®]

VOICE SET

2Use the [A]/[B] buttons to select a keyboard part.

3Use the [4π†]–[7π†] buttons to enable/disable automatic calling up of the settings (ON or OFF) independently for each parameter group.

Refer to the Data List for a list of parameters contained in each parameter group. The Data List is available at the Yamaha website. (See page 5.)

98

PSR-OR700 Owner’s Manual