Yamaha PSR-OR700 The, Operation, •KEYBOARD, ●Tx MONITOR, •EXTRA PART, ●Rx MONITOR, MIDI Receive Settings, ■MIDI messages which can be transmitted or received (recognized)

MIDI Settings

●Tx MONITOR

The dots corresponding to each channel (1-16) flash briefly whenever any data is transmitted on the chan- nel(s).

n

When different parts are assigned to the same transmit channel

If the same transmit channel is assigned to several different parts, the transmitted MIDI messages are merged to a single channel — resulting in unexpected sounds and possible glitches in the connected MIDI device.

n

About the protected Songs

Write-protected Songs cannot be transmitted even if the proper Song channels 1–16 are set to be transmitted.

■MIDI messages which can be transmitted or received (recognized)

The following MIDI messages can be set on the TRANS- MIT/RECEIVE display.

• Note (Note events).......................................	page 164
• CC (CONTROL CHANGE) ..........................	page 164
• PC (PROGRAM CHANGE)...........................	page 164
• PB (Pitch Bend)............................................	page 164
• AT (Aftertouch).............................................	page 164
	RECEIVE display

MIDI Receive Settings

The explanations here apply to the RECEIVE display to be called up in step 4 of the “Basic Operation” on page 177. This determines which parts will receive MIDI data and over which MIDI channels the data will be received.

Operation

Select the channel to be received and the part via which the selected channel will be received. You can also determine the types of data to be received.

●The PSR-OR700 can receive MIDI messages over 32 channels (16 channels x 2 ports) by USB con- nection.

●With the exception of the next two parts, the configuration of the parts is the same as those already explained elsewhere in this manual.

•KEYBOARD

The received note messages control the instrument’s keyboard performance.

•EXTRA PART 1-5

There are five parts specially reserved for receiving and playing MIDI data. Normally, these parts are not used by the instrument itself. The PSR-OR700 can be used as a 32-channel multi-timbral tone generator by using these five parts in addition to the general parts.

●Rx MONITOR

The dots corresponding to each channel (1–16) flash briefly whenever any data is received on the channel(s).

n

Parameter Lock

You can “lock” specific parameters (e.g., effect, split point, etc.) to make them selectable only via the panel controls (page 133).

■MIDI transmission/reception via the USB ter- minal and MIDI terminals

The relationship between the [MIDI] terminals and the [USB] terminal which can be used for transmitting/ receiving 32 channels (16 channels x 2 ports) of the MIDI messages is as follows:

	MIDI reception							MIDI transmission
					[USB TO				[USB TO
[MIDI IN] jack					HOST] jack		[MIDI OUT] jack HOST] jack
					Port
					handling
			USB1			USB2
		Merge		Merge
	MIDI/USB1				USB2				MIDI/USB 01–16
	01–16				01–16

with Instrument Your Using

Devices Other

PSR-OR700 Owner’s Manual 181