Yamaha RX-V663 36 En, RETRY, display, Choices: RETRY, EXIT, ■If “WARNING” appears, ■If an error screen appears, 16Press MMENU to exit from “SET MENU”

Optimizing the speaker setting for your listening room (YPAO)

15Press 8ENTER to confirm your selection.The top “SET MENU” screen appears in the OSD.

SET MENU

.;AUTO SETUP

;MANUAL SETUP

.A;SIGNAL INFO

[p]/[p]:Up/Down [ENTER]:Enter

16Press MMENU to exit from “SET MENU”.

If you change speakers, speaker positions, or the layout of your listening environment, run “AUTO SETUP” again to recalibrate your system.

■If an error screen appearsPress 8k/ n/ l/ hto select “RETRY” or “EXIT” and then press 8ENTER.The following display is an example when “E-9:USER CANCEL” appears in the OSD.

ERROR

.E-9:USER CANCEL Don't operate

any function

>RETRY EXIT

[[]/[[]:Select [ENTER]:Enter

Choices: RETRY, EXIT•Select “RETRY” to retry the “AUTO SETUP” procedure.•Select “EXIT” to exit from the “AUTO SETUP” procedure.

If “E-5:NOISY” appears, “PROCEED” also appears in the choices. When you select “PROCEED”, this unit continues the measurements and settings, but the settings may not be optimal.

■If “WARNING” appears

When this unit detects potential problems during the “AUTO SETUP” procedure, “WARNING” appears in the top result display. Check the warning messages to correct your speaker settings.

Note

Warnings differ from errors in that warnings do not cancel the “AUTO SETUP” procedure.

1Make sure the pointer is pointing at “WARNING” and then press 8ENTER todisplay the detailed information about the warning.The number on the right of “WARNING” indicates the number of warning messages.

AUTOSETUP

.WARNING(3)

RESULT

SP : 3/4/0.1

DIST: 14.0/17.0ft

LVL : -9.0/+6.5dB

>SET CANCEL

[]/[ ]:Up/Down [ENTER]:Detail

2Press 8l/ hrepeatedly to toggle between the warning displays.

WARNING

W-1:OUTOFPHASE

Reverse Channel

FL --

CENTER
PL	PR
SL	SR
SBL	SBR

[[]/[[]:Select

[ENTER]:Return

•For details about each warning message, see the “AUTO SETUP” section in “Troubleshooting” on page 117.

•When the corresponding warning message is not applicable to a speaker, “––” is displayed instead.

•If “SWFR: TOO LOUD” or “SWFR: TOO LOW” appearsin the “W-3: LEVEL ERROR” display, adjust the volume level of the subwoofer(s).3Press 8ENTER to return to the top resultdisplay.