Troubleshooting 103
Printer Diagnostics
FEED and PAUSE Self Test
Performing this self test temporarily resets the printer configuration to the factory default values. These values are active only until power is turned off unless you save them permanently in memory. If the factory default values are permanently saved, a media calibration procedure must be performed.
To perform a FEED and PAUSE self test, complete these steps:
1.Turn Off (O) the printer.
2.Press and hold FEED and PAUSE while turning the power On (I).
3.Hold FEED and PAUSE until the first control panel light turns off.
The printer configuration is temporarily reset to the factory default values. No labels print at the end of this test.
Communications Diagnostics Test
Do not perform the following test until all configuration and calibration parameters have been set. For configuration information, see Control Panel LCD Display on page 60.
This test is controlled from the control panel LCD display. See Hex Dump on page 69. Figure 33 shows a typical printout from this test. Turn the printer power Off (O) and then back On (I) to exit this self test and return to normal operation.
Note • This test label prints
Figure 33 • Communications Diagnostics Test Label
10/21/05 | S4M User Guide |