64Configuration

Control Panel LCD Display

Table 10 • Printer Parameters, Password Levels 1 and 2 (Page 5 of 5)

Parameter

Explanation

CONTROL CODES

Set APL-D Control Codes

(APL-D mode only)

Selections: STANDARD, MAINFRAME

 

Default Value: STANDARD

 

To modify this parameter:

 

• Press the up or down arrow to scroll through the selections.

MODULE A

Set Module A Storage Device for APL-D

(APL-D mode only)

Selections: NONE, RAM 1, RAM 2, FLASH 1, FLASH 2

 

Default Value: NONE

 

To modify this parameter:

 

• Press the up or down arrow to scroll through the selections.

MODULE B

Set Module B Storage Device for APL-D

(APL-D mode only)

Selections: NONE, RAM 1, RAM 2, FLASH 1, FLASH 2

 

Default Value: NONE

 

To modify this parameter:

 

• Press the up or down arrow to scroll through the selections.

 

 

RESOLUTION

Set Printer Resolution for APL-I

(APL-I mode only)

Sets the dot size for backward compatibility with some older APL-I

 

printers.

 

Selections: 5 MIL, 10 MIL, 15 MIL

 

Default Value: 5 MIL

 

To modify this parameter:

 

• Press the up or down arrow to scroll through the selections.

 

 

LENGTH

Set Maximum Label Length

 

Maximum label length is used in conjunction with the calibration

 

procedure. The value of this setting is the maximum label length that is

 

used during the media portion of the calibration process. Only a few labels

 

are required to set media sensors. Always set the value that is at least 1 in.

 

(25.4 mm) longer than the longest label to be used on the printer.

 

Selections: AUTO, < 1 INCH (25.4 mm) to < 39 INCH (991 mm)

 

Default Value: AUTO

To modify this parameter:

•To increase the value, press the up arrow.

•To decrease the value, press the down arrow.

13290L-001 Rev. A

S4M User Guide

10/21/05