Configuration

 

71

 

 

 

Control Panel LCD Display

 

 

 

Table 11 • Printer Parameters, Level 3 (Page 7 of 9)

 

 

 

Parameter

Explanation

 

 

ZPL OVERRIDE

Override Certain ZPL Commands

 

(ZPL mode only)

Prevents the printer from accepting the following ZPL commands:

 

• ^MM (media mode)

 

• ^MT (media type direct thermal or thermal transfer)

 

• ^MN (media non-continuous or continuous)

 

Selections:

 

• NO—allows the printer to accept the listed ZPL commands.

 

• YES—tells the printer to ignore the listed ZPL commands.

 

Default Value: NO

 

To modify this parameter:

 

• Press the up or down arrow to scroll through the selections.

 

 

 

EPL OVERRIDE

Override Certain EPL Commands

(EPL mode only)

Prevents the printer from accepting certain EPL commands.

 

Selections:

 

• DISABLED—allows the printer to accept the listed EPL commands.

 

• ENABLED—tells the printer to ignore the listed EPL commands.

 

Default Value: DISABLED

 

To modify this parameter:

 

• Press the up or down arrow to scroll through the selections.

 

 

 

SENSOR PROFILE

Print Sensor Profile

 

Use the sensor profile (Figure 26) to troubleshoot registration problems

 

that may occur if the media sensor detects preprinted areas on the media or

 

if it experiences difficulty in determining web location. To adjust the

 

sensitivity of the media and/or ribbon sensors, use Calibrate Media and

 

Ribbon Sensors on page 72.

 

Note • The ribbon portion of the label appears only for printers

 

that have the Thermal Transfer option installed.

 

Figure 26 • Sensor Profile

To select this parameter:

1.Press ENTER to start this standard calibration procedure and print a media sensor profile.

10/21/05

S4M User Guide

13290L-001 Rev. A