Configuration 61

Control Panel LCD Display

Table 10 • Printer Parameters, Password Levels 1 and 2 (Page 2 of 5)

Parameter

Explanation

 

 

TEAR OFF

Adjust Tear-Off Position

 

This parameter establishes the position of the labels over the

 

tear-off/peel-off bar after printing. Each press of a button adjusts the tear-

 

off position by one dot row.

 

Note • The printer applies and saves the tear-off setting

 

immediately. Exiting Setup mode without saving changes does not

 

restore the previous value.

 

Range (ZPL, EPL, APL-I): -120 to +120

 

Default Value (ZPL, EPL, APL-I): 0

 

Range (APL-D):+00i to +999i (inches), 0m to 2537m (metric)

 

Default Value (APL-D): +128i

 

Note • The APL-D default value does not position the label over

 

the tear-off/peel-off bar. This is done to work with existing DPL

 

label formats that account for this positioning.

 

To modify this parameter:

 

• Press the up arrow to increase value.

 

• Press the down arrow to decrease value.

 

 

LABEL TOP

Adjust Label Top Position

(ZPL, EPL, and APL-D

The label top position adjusts the print position vertically on the label.

modes)

Positive numbers adjust the label top position farther down the label (away

X FORMS ADJUST

from the printhead), and negative numbers adjust the position up the label

(APL-I mode only)

(toward the printhead).

 

The displayed value represents dots.

 

Range (ZPL, EPL, and APL-I): -120 to +120

 

Default Value (ZPL, EPL, and APL-I): 0

 

Range (APL-D):-0.64i to 0.64i (when printer is set to operate in inches)

 

Default Value (APL-D): 0

 

To modify this parameter:

 

• To increase the value, press the up arrow.

 

• To decrease the value, press the down arrow.

 

 

Y FORMS ADJUST

Adjust Label Left Position

(APL-I mode only)

The label left position adjusts the print position horizontally on the label.

 

Positive numbers move the left edge of the image toward the center of the

 

label by the number of dots selected while negative numbers shift the left

 

edge of the image toward the left edge of the label.

 

Range: -120 to +120

 

Default Value: 0

To modify this parameter:

•To increase the value, press the up arrow.

•To decrease the value, press the down arrow.

10/21/05

S4M User Guide

13290L-001 Rev. A