Printer Setup 19

Connect the Printer to a Power Source

Connect the Printer to a Power Source

The AC power cord must have a three-prong female connector on one end that plugs into the mating AC power connector at the rear of the printer. If a power cable was not included with your printer, refer to Power Cord Specifications on page 20.

Caution • For personnel and equipment safety, always use an approved three-conductor power cord specific to the region or country intended for installation. This cord must use an IEC 320 female connector and the appropriate region-specific three-conductor grounded plug configuration.

To connect the printer to a power source, complete these steps:

1.Turn the printer power switch to the Off (O) position.

2.Refer to Figure 6. Plug the power cord into the AC power connector on the rear of the printer.

3.Plug the other end of the power cord into a power outlet near the printer.

Figure 6 • Power Connection

1

2

1Power switch

2AC power connector

10/21/05

S4M User Guide

13290L-001 Rev. A