66Configuration

Password Protection of Parameters

Password Protection of Parameters

The printer has four levels of passwords. When you enter Setup mode on the control panel, only those parameters that are not password-protected are displayed. To see more parameters, you must enter an appropriate password at the ADVANCED SETUP prompt. After you enter a password correctly, you do not have to enter it again until you leave and reenter Setup mode.

When you are prompted for a password, enter the password for the level displayed or for a higher level. Entering a higher level password will unprotect the parameters for that level and for all levels below it (for example, unprotecting level 4 parameters also unprotects levels 1, 2, and 3).

The password levels and default passwords are shown in Table 11. To change the password for any level, use the ^KP ZPL II command.

Table 11 • Password Levels and Defaults

Password

Features Controlled

Default Password

Level

 

 

 

 

 

4

All features, including sensor adjustments

For advanced use only. See the

 

and other sensitive parameters

Maintenance Manual or contact

 

 

technical support.

 

 

 

3

Installation and reconfiguration. The printer

1234

 

web-page interface also uses this password.

 

2

Label configuration operations (media type,

0000 (unprotected)

 

label removal method, label length)

 

1

Darkness, Tear-Off position, label top

0000 (unprotected)

To enter a password when prompted, complete these steps:

1.When the printer displays ADVANCED SETUP X, press ENTER. The printer displays PASSWORD and the number 0000.

2.Enter the four-digit password for the password level displayed or for a higher level.

•The left and right arrows change the selected digit position.

•The up and down arrows change the value of the selected digit.

3.After entering the password, press ENTER.

If you entered a valid password, additional parameters are displayed.

13290L-004 Rev. A

S4M User Guide

6/15/09