Configuration 81
Control Panel Parameters
Table 15 • Printer Parameters, Password Level 3 (Page 5 of 10)
Parameter | Explanation |
|
|
DELIM. CHAR | Set Delimiter Character |
(ZPL mode only) | The delimiter character is a |
| parameter place marker in ZPL/ZPL II format instructions. See the ZPL II |
| Programming Guide for more information. |
| Note • Do not use the same hexadecimal value for the control, |
| command, and delimiter character. The printer must see different |
| characters to work properly. |
| Range: 00 to FF |
| Default Value: 2C (comma) |
| To modify this parameter: |
| • To increase the value, press the up arrow. |
| • To decrease the value, press the down arrow. |
|
|
HEXDUMP | Hex Dump |
| The hexadecimal dump mode is a troubleshooting tool for checking the |
| interconnection between the printer and the host computer. For more |
| information, see Communications Diagnostics Test on page 121. |
| Selections: NO, YES |
| Default Value: NO |
| To modify this parameter: |
| • Press the up or down arrow to scroll through the selections. |
|
|
REPRINT MODE | Reprint Mode |
(ZPL mode only) | When Reprint Mode is enabled, the ~PR ZPL command can be used to |
| reprint the last label. If the Reprint feature is disabled, the ~PR command |
| is ignored. (Equivalent to the reprint mode parameter in the ^JJ ZPL |
| command.) |
| Selections: ENABLED, DISABLED |
| Default Value: DISABLED |
|
|
CHANGE RTC DATE | Set RTC |
| If RTC is installed, this parameter allows you to set the RTC date. |
| Note • The printer saves the RTC date immediately. |
To modify this parameter:
1.Press ENTER.
The printer displays the current RTC date.
2.Modify the values as follows:
•Press the right arrow to move to the next digit position.
•To increase the value, press the up arrow.
•To decrease the value, press the down arrow.
3.Press ENTER to accept the value shown.
6/15/09 | S4M User Guide |