Configuration 73

Control Panel Parameters

Table 14 • Printer Parameters, Password Levels 1 and 2 (Page 2 of 5)

Parameter

Explanation

 

 

TEAR OFF

Adjust Tear-Off Position

 

This parameter establishes the position of the labels over the

 

tear-off/peel-off bar after printing.

 

Note • The printer applies and saves the tear-off setting

 

immediately. Exiting Setup mode without saving changes does not

 

restore the previous value.

 

Range (ZPL, EPL, APL-I): -120 to +120

 

Default Value (ZPL, EPL, APL-I): 0

 

Range (APL-D):+00i to +999i (0m to 2537m)

 

Default Value (APL-D): +128i

 

To modify this parameter:

 

• Press the up arrow to increase value.

 

• Press the down arrow to decrease value.

 

 

LABEL TOP

Adjust Label Top Position

(ZPL, EPL, and APL-D

The label top position adjusts the print position vertically on the label.

modes)

Positive numbers adjust the label top position farther down the label (away

X FORMS ADJUST

from the printhead), and negative numbers adjust the position up the label

(APL-I mode only)

(toward the printhead).

 

Range (ZPL, EPL): -120 to +120

 

Range (APL-I): -10 to +4000

 

Range (APL-D): -0.64i to 0.64i

 

Default Value: 0

 

To modify this parameter:

 

• To increase the value, press the up arrow.

 

• To decrease the value, press the down arrow.

 

 

LEFT POSITION

Adjust Label Left Position

(ZPL, EPL, and APL-D

The label left position adjusts the print position horizontally on the label.

modes)

Positive numbers move the left edge of the image toward the center of the

Y FORMS ADJUST

label while negative numbers shift the left edge of the image toward the

(APL-I mode only)

left edge of the label.

 

Range (ZPL, EPL, APL-D): -120 to +120

 

Range (APL-I): -9999 to +9999

 

Default Value: 0

To modify this parameter:

•To increase the value, press the up arrow.

•To decrease the value, press the down arrow.

6/15/09

S4M User Guide

13290L-004 Rev. A