Zebra Technologies S4M manual 80

80Configuration

Control Panel Parameters

Table 15 • Printer Parameters, Password Level 3 (Page 4 of 10)

Parameter	Explanation
HOST HANDSHAKE	Set Host Handshake
	The handshake protocol of the printer must match the handshake protocol
	of the host computer for proper communications to take place. Select the
	handshake protocol that matches the one being used by the host computer.
	Selections (ZPL, APL-D):XON/XOFF, DSR/DTR, RTS/CTS
	Selections (APL-I):XON/XOFF, DSR/DTR, RTS/CTS, APL-I
	Default Value (ZPL, APL-D, APL-I): XON/XOFF
	Selections (EPL): DTR & XON/XOF, DTR
	Default Value (EPL): DTR & XON/XOF
	Note • XOFF is abbreviated as XOF on the EPL display.
	To modify this parameter:
	• Press the up or down arrow to scroll through the selections.
CONTROL CHAR	Set Control Character
(ZPL mode only)	The printer looks for this two-digit hexadecimal character to indicate the
	start of a ZPL/ZPL II control instruction.
	Note • Do not use the same hexadecimal value for the control,
	command, and delimiter character. The printer must see different
	characters to work properly.
	Range: 00 to FF
	Default Value: 7E (tilde—displayed as an arrow)

To modify this parameter:

•To increase the value, press the up arrow.

•To decrease the value, press the down arrow.

COMMAND CHAR	Set Command Character
(ZPL mode only)	The command prefix is a two-digit hexadecimal value used as a parameter
	place marker in ZPL/ZPL II format instructions. The printer looks for this
	two-digit hexadecimal character to indicate the start of a ZPL/ZPL II
	format instruction. See the ZPL II Programming Guide for more
	information.
	Note • Do not use the same hexadecimal value for the control,
	command, and delimiter character. The printer must see different
	characters to work properly.

Range: 00 to FF

Default Value: 5E (caret)

To modify this parameter:

•To increase the value, press the up arrow.

•To decrease the value, press the down arrow.

13290L-004 Rev. A S4M User Guide 6/15/09