82Configuration

Control Panel Parameters

Table 15 • Printer Parameters, Password Level 3 (Page 6 of 10)

Parameter

Explanation

CHANGE RTC TIME

Set RTC (Real-time clock) Time

 

If RTC is installed, this parameter allows you to set the RTC time.

 

 

Note • The printer saves the RTC time immediately.

 

To modify this parameter:

 

1.

Press ENTER.

 

 

The printer displays the current RTC time.

 

2.

Modify the values as follows:

 

 

• Press the right arrow to move to the next digit position.

 

 

• To increase the value, press the up arrow.

 

 

• To decrease the value, press the down arrow.

 

3.

Press ENTER to accept the value shown.

 

 

LOAD DEFAULTS

Load Factory Defaults

 

Sets all parameters back to factory defaults.

 

 

Important • Use care when using this command. All printer

 

 

parameters are reset to factory values with this command. If

 

 

possible, print a configuration label to have as a record of the

 

 

printer’s settings before loading defaults.

 

How to select this parameter:

 

1.

Press ENTER.

 

 

The printer asks ARE YOU SURE?

 

2.

To load factory defaults, press ENTER to select YES. To cancel, press

 

 

any other key.

 

 

DEFAULT NET

Reset Network Parameters

 

Resets the network parameters back to the factory defaults.

 

1.

Press ENTER.

 

 

The printer asks ARE YOU SURE?

 

2.

To reset network parameters to the factory defaults, press ENTER to

 

 

select YES. To cancel, press any other key.

 

 

INIT FLASH MEM

Initialize Flash Memory

 

This parameter allows you to erase the printer’s Flash memory.

 

 

Important • The internal Flash memory is entirely erased with this

 

 

command.

To select this parameter:

1.Press ENTER to select YES.

The printer asks ARE YOU SURE?

2.To initialize Flash memory, press ENTER. To cancel, press any other key.

13290L-004 Rev. A

S4M User Guide

6/15/09