Zoom 8080 FLG, FLG, Use, Use, 3 to, 4 to, once to, CSW=DLY, CP2=DST, parameter, parameter, selected), 5 Press the, Ž 2 CP1=DST, CONTROL SET:, where the RTM

CONTROL

PEDAL

If desired, store the patch.

CONTROL pedal 1

5 Press the	Except for the TOTAL and EQ
UTILITY/PAGE key once to	modules, page 2 of every effect
display the RTM	module includes the RTM
parameter.	parameter.

FLG

ŽRTM=SPD DIR=NML

"RTM" (RTM destination) stands for the parameter to be controlled by RTM. "DIR" (RTM direction) stands for the direction in which the parameter is to be controlled.

6	Data entry knob
			FLG
	Use	3 to
			Ž	RTM=FB DIR=NML
	select the parameter
	(only for effect types
	where the RTM
	destination can be
	selected).

7	Data entry knob		You can select either "NML"			The meaning of "NML" and "INV"
			(normal) or "INV" (inverted).			depends on the effect type
Use		4 to
select the direction						controlled by the pedal.
for the "RTD=" item.				Controlling VIB (Vintage Vibe) and PPIT (Pedal Pitch Shifter) with the pedals
					Pedal released		Pedal depressed
				NML	Minimum		Maximum
				INV	Maximum		Minimum
				Controlling effect types of DIST effect module with the pedals
					Pedal released		Pedal depressed
				NML ( Minimum value for setting)			Preset parameter value
				INV	Preset parameter value		( Minimum value for setting)
				Controlling other effect types with the pedal
					Pedal released		Pedal depressed
				NML	Minimum		Preset parameter value
				INV	Preset parameter value		Maximum

Operation Advanced

8

9

Operate while playing the instrument.

("Storing an edited patch" p. 23).

The selected effect module parameter changes according to the pedal movement. In this example, the compression depth can be adjusted with the pedal. CONTROL pedal 2 can be assigned in the same way.

For effect types where the RTM destination can be HINT changed (some effect types in effect modules EFF2 and EFF3), the indication "RTM=" is shown on the display, and data entry knob 3 can be used to select the parameter. For effect types where the RTM destination is

fixed, "RTM →" is shown on the display.

✎The "Minimum" value of the DIST module depends on the N distortion type and the parameter setting value.

HINT In Play mode, the	01 8080LEAD LVL=100
lower line of the	AMP ÁEF2 ªOFF §HLD
display shows the
modules assigned to
CONTROL pedals 1
	CP1 setting CP2 setting
and 2.

HINT In principle, CONTROL pedal 1, CONTROL pedal 2, and the CONTROL switches cannot be used to control the

same effect module. If an attempt is made to assign several controllers to the same module in step 3 (TOTAL module setting), priority will automatically be set in the order CP1, CP2, CSW.

TOTAL module settingPlay mode display

CONTROL SET:	CSW=DLY	01 8080LEAD LVL=100
Ž 2 CP1=DST	CP2=DST	AMP ÁDST ªOFF §HLD
If the same module was		CP1 is selected and CP2
assigned to CP1 and CP2 ...		becomes "OFF".

The minimum value of the distortion gain control varies ✎N according to the type of distortion and the parameter settings.

The minimum value achieved by these changes may be smaller than Gain 1, depending on the settings.

25■