Troubleshooting

Symptom

 

Check

 

Remedy

 

 

 

 

 

APPENDIX

No sound or very low volumePatches cannot be switchedCONTROL pedals or CONTROL switches have no effect

•Are shielded cables connected properly?

•Is the guitar connected properly to the INPUT jack of the 8080 and the amplifier to the OUTPUT jack of the 8080?

•Is a shielded cable defective?

•Is the connected guitar amplifier turned on?

•Are level controls on guitar and amplifier set properly?

•Are level controls and parameters of 8080 set properly (OUTPUT control, patch level, VOL/LEVEL parameters)?

•Gain parameter of EQ effect set too low?

•Are CONTROL pedals and CONTROL switches set too low?

•Is the mute condition active?

•Is Edit mode activated?

•Is unit in standby condition for store or all- initialize?

•Is effect module selected in CONTROL SET (TOTAL module) turned on?

•Are DIR (direction) parameter and control parameters set properly?

For example, if PWA module is assigned to a CONTROL pedal and the DIR parameter of the PWA module is set to "NML", the controlled FRQ parameter changes only from the minimum value to the current setting. If the minimum value is set to "1", pressing the pedal will have no effect.

Make connections as described in "Connections" and then turn the unit on.

Make connections as described in "Connections" and then turn the unit on.

Try replacing the cable.

Turn amplifier on.

Adjust controls to achieve suitable volume.

Activate Edit mode and adjust parameters.

Activate Edit mode and adjust parameters.

( p.54)

Operate CONTROL pedals and CONTROL switches.

Press foot switch with flashing indicator to turn muting off.

Press EDIT/EXIT key to return to Play mode.

Press the STORE/EXECUTE key to carry out the function, or press the EDIT/EXIT key to cancel.

Activate Edit modeand adjust parameters.

( p. 63)

Activate Edit mode and adjust parameters.

■68