4
5
If desired, store the patch.
Operatethe CONTROL switches while
playing the instrument.("Storing an edited patch" p. 23).
Pressing the INCREASE switch increases the parameter value in discrete steps, and pressing the DECREASE switch decreases it. The current setting can be verified with the CONTROL SWITCH INDICATOR.
CONTROL
SWITCH
INDICATOR
MAX
1/2
MIN
BLINK (DLY:TAP)
INCREASE
CONTROL
SWITCH
DECREASE
–(TAP/HOLD)
Operation Advanced
Unlike when using the CONTROL pedal 1 and 2, there is no need to set "DIR" (control direction) for the assigned effect ✎NOmodule. The INCREASE switch always increases the parameter and the DECREASE switch always decreases it.
HINT In Play mode, the lower line of the display shows the module assigned to the CONTROL switches.
01 8080LEAD LVL=100 AMP ÁVOL ªOFF §DST
CSW setting
HINT In principle, CONTROL pedal 1, CONTROL pedal 2, and the CONTROL switches cannot be used to control the same effect module. However, if the "CSW" parameter in the DLY module is set to a different item than the "RTM" parameter, the DLY module can be assigned to CONTROL pedal 1 or 2 and the CONTROL switches at the same time.
DLY module RTM pageTOTAL module settingPlay mode display
| DLY HiD= | 0 TYP= MN |
| CONTROL SET: | CSW=DLY |
| 01 8080LEAD LVL=100 | ||
| RTM | Mix CSW=Tap |
| Ž 2 CP1=DLY | CP2=DST |
| AMP ÁDMx ÁOFF §Tap | ||
|
|
|
|
|
|
| ||
|
|
|
| |||||
|
|
|
|
| ||||
If "RTM" and "CSW" are set to | ...and CP1 and CSW are set to the | ...both controllers are active. | ||||||
different settings... | DLY module in the TOTAL module... |
|
|
| ||||
HINT Briefly tapping a CONTROL switch changes the value by 1/10 of the total adjustment range. Keeping a CONTROL switch depressed causes the value to change continuously in steps of 1 unit (but the CONTROL SWITCH INDICATOR shows changes in
27■