Other Functions

This section explains how to use the 8080 for controlling an external effect device or amplifier, and how to use the Initialize mode to reset the 8080 to the factory default condition.

Controlling an external effect device

SERIAL NO.

 

 

 

 

DC9V1.0A

POWER MIDI OUT

 

EXTERNAL DIST

 

OUTPUT

EXT

 

INPUT GAIN INPUT

SEND RETURN +4dB

PHONES

R

L/MONO

+4dB CTRL OUT

 

H M L

–20dB

 

 

 

–20dB

MODEL 8080 ZOOM CORPORATION

 

 

 

 

 

 

MADE IN JAPAN/FABRIQUE AU JAPON

1 EXTERNAL DIST SEND / RETURN jack

EXTERNAL DIST

SEND RETURN

1

2

3

4

Connect the device in

the

EXTERNAL

DIST SEND / RETURN jack

 

loop of the 8080 ( p. 7).

Activate the Edit mode and select "EXT" (external distortion) as the effect type of the DIST module.

If required, set the "BST" (booster type), "SND" (send level), and "LVL" (signal level for next module) parameters.

Store the patch as required.
EXT BST=OFF SND=offLVL= 1 ZNR=offWhen this patch is selected, the external effect device in theEXTERNAL DIST SEND/RETURN loop of the 8080 can be used.

Operation Advanced

Leave the external effect device always turned on and perform simulated on/off switching at the 8080. ✎NO

✎ When an external effect is selected, but nothing is connected to the RETURN jack, the sound will not be interrupted, because the 8080 NOinternally sends the signal to the next module. However, the EXT module parameters settings will be active, so that the sound may be different

from the sound with the SND parameter set to "off".

41■