Chapter 12 Bandwidth Control
Table 27 Advanced Application > Bandwidth Control (continued)
LABEL | DESCRIPTION |
* | Settings in this row apply to all ports. |
| Use this row only if you want to make some settings the same for all ports. Use this |
| row first to set the common settings and then make adjustments on a |
| basis. |
| Note: Changes in this row are copied to all the ports as soon as you |
| make them. |
|
|
Active | Make sure to select this check box to activate ingress rate limit on this port. |
|
|
Ingress Rate | Specify the maximum bandwidth allowed in Kilobits per second (Kbps) for the |
| incoming traffic flow on a port. |
| If you enter a number between 64 and 1728, the Switch automatically rounds the |
| number down to the nearest multiple of 64. |
| If you enter a number between 1729 and 1999, the rate is fixed at 1792. |
| If you enter a number between 2000 and 103999, the Switch rounds the number down |
| to the nearest multiple of 1000. |
| On a Gigabit Ethernet/ |
| nearest multiple of 8000 for a number between 104000 and 1000000. |
|
|
Active | Select this check box to activate egress rate limit on this port. |
|
|
Egress Rate | Specify the maximum bandwidth allowed in Kilobits per second (Kbps) for the out- |
| going traffic flow on a port. |
| If you enter a number between 64 and 1728, the Switch automatically rounds the |
| number down to the nearest multiple of 64. |
| If you enter a number between 1729 and 1999, the rate is fixed at 1792. |
| If you enter a number between 2000 and 103999, the Switch rounds the number down |
| to the nearest multiple of 1000. |
| On a Gigabit Ethernet/ |
| nearest multiple of 8000 for a number between 104000 and 1000000. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| these changes if it is turned off or loses power, so use the Save link on the top |
| navigation panel to save your changes to the |
| configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
110 |
| |
| ||
|
|
|