|
| Chapter 7 Basic Setting |
| Table 11 Basic Setting > IP Setup (continued) | |
| LABEL | DESCRIPTION |
| Static IP | Select this option if you don't have a DHCP server or if you wish to assign static IP |
| Address | address information to the Switch. You need to fill in the following fields when you |
|
| select this option. |
|
|
|
| IP Address | Enter the IP address of your Switch in dotted decimal notation for example |
|
| 192.168.1.1. |
|
|
|
| IP Subnet | Enter the IP subnet mask of your Switch in dotted decimal notation for example |
| Mask | 255.255.255.0. |
|
|
|
| Default | Enter the IP address of the default outgoing gateway in dotted decimal notation, for |
| Gateway | example 192.168.1.254 |
|
|
|
| VID | Enter the VLAN identification number associated with the Switch IP address. This is |
|
| the VLAN ID of the CPU and is used for management only. The default is "1". All |
|
| ports, by default, are fixed members of this "management VLAN" in order to manage |
|
| the device from any port. If a port is not a member of this VLAN, then users on that |
|
| port cannot access the device. To access the Switch, make sure the port that you are |
|
| connected to is a member of Management VLAN. |
|
|
|
| Apply | Click Apply to save your changes to the Switch’s |
|
| these changes if it is turned off or loses power, so use the Save link on the top |
|
| navigation panel to save your changes to the |
|
| configuring. |
|
|
|
| Cancel | Click Cancel to reset the fields to your previous configuration. |
|
|
|
| Management IP Addresses | |
| Configure the fields to set additional management IP address. | |
|
|
|
| IP Address | Enter the IP address for managing the Switch by the members of the VLAN specified |
|
| in the VID field below. |
|
|
|
| IP Subnet | Enter the IP subnet mask in dotted decimal notation. For example, 255.255.255.0. |
| Mask |
|
|
|
|
| VID | Enter the VLAN identification number. |
|
|
|
| Default | Enter the IP address of the default outgoing gateway in dotted decimal notation, for |
| Gateway | example 192.168.1.254 |
|
|
|
| Add | Click Add to save the new rule to the Switch. It then displays in the summary table at |
|
| the bottom of the screen. |
|
| The Switch loses these changes if it is turned off or loses power, so use the Save link |
|
| on the top navigation panel to save your changes to the |
|
| you are done configuring. |
|
|
|
| Cancel | Click Cancel to reset the fields to your previous configuration. |
|
|
|
| Index | This field displays the index number of an entry. |
|
|
|
| IP Address | This field displays the management IP address of the Switch. |
|
|
|
| IP Subnet | This field displays the subnet mask for the corresponding IP address. |
| Mask |
|
|
|
|
| VID | This field displays the VLAN identification number of the network. |
|
|
|
| Default | This field displays the IP address of default gateway. |
| Gateway |
|
|
|
|
| Delete | Click Delete to remove the selected entry from the summary table. |
|
|
|
| Cancel | Click Cancel to clear the Delete check boxes. |
|
|
|
| 73 |
|
|