ZyXEL Communications ES-2024 Series 232

Chapter 33 Configure Clone

The following table describes the labels in this screen.

Table 96 Management > Configure Clone

LABEL	DESCRIPTION
Source/	Enter the source port under the Source label. This port’s attributes are copied.
Destination	Enter the destination port or ports under the Destination label. These are the ports
Port	which are going to have the same attributes as the source port. You can enter
	individual ports separated by a comma or a range of ports by using a dash.
	Example:
	• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
	• 2-6indicates that ports 2 through 6 are the destination ports.

Basic Setting	Select which port settings (you configured in the Basic Setting menus) should be
	copied to the destination port(s).

Advanced	Select which port settings (you configured in the Advanced Application menus)
Application	should be copied to the destination ports.

Apply	Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
	these changes if it is turned off or loses power, so use the Save link on the top
	navigation panel to save your changes to the non-volatile memory when you are done
	configuring.

Cancel	Click Cancel to begin configuring this screen afresh.