Chapter 26 Maintenance

Table 71 Management > Maintenance (continued)

LABEL

DESCRIPTION

Save

Click Config 1 to save the current configuration settings to Configuration 1 on the

Configuration

Switch.

 

 

Reboot

Click Config 1 to reboot the system and load Configuration 1 on the Switch.

System

 

 

Note: Make sure to click the Save button in any screen to save your

 

settings to the current configuration on the Switch.

 

 

26.2 Load Factory Default

Follow the steps below to reset the Switch back to the factory defaults.

1In the Maintenance screen, click the Click Here button next to Load Factory Default to clear all Switch configuration information you configured and return to the factory defaults.

2Click OK to reset all Switch configurations to the factory defaults.

Figure 107 Load Factory Default: Start

3In the web configurator, click the Save button to make the changes take effect. If you want to access the Switch web configurator again, you may need to change the IP address of your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).

26.3Save Configuration

Click Config 1 to save the current configuration settings permanently to Configuration 1 on the Switch.

Alternatively, click Save on the top right-hand corner in any screen to save the configuration changes to the current configuration.

"Clicking the Apply or Add button does NOT save the changes permanently. All unsaved changes are erased after you reboot the Switch.

192

 

ES-2024 Series User’s Guide