Chapter 15 Link Aggregation
•You must connect all ports
•LACP only works on
•All ports in the same trunk group must have the same media type, speed, duplex mode and flow control settings.
Configure trunk groups or LACP before you connect the Ethernet switch to avoid causing network topology loops.
15.2.1 Link Aggregation ID
LACP aggregation ID consists of the following information1:
Table 30 | Link Aggregation ID: Local Switch |
|
| ||
SYSTEM PRIORITY | MAC ADDRESS | KEY | PORT PRIORITY | PORT NUMBER | |
0000 |
| 0000 | 00 | 0000 | |
|
|
|
|
|
|
Table 31 | Link Aggregation ID: Peer Switch |
|
| ||
SYSTEM PRIORITY | MAC ADDRESS | KEY | PORT PRIORITY | PORT NUMBER | |
0000 |
| 0000 | 00 | 0000 | |
|
|
|
|
|
|
15.3 Link Aggregation Status
Click Advanced Application > Link Aggregation in the navigation panel. The Link Aggregation Status screen displays by default. See Section 15.1 on page 115 for more information.
Figure 52 Advanced Application > Link Aggregation Status
The following table describes the labels in this screen.
Table 32 Advanced Application > Link Aggregation Status
LABEL | DESCRIPTION |
Index | This field displays the trunk ID to identify a trunk group, that is, one logical link |
| containing multiple ports. |
|
|
Enabled Ports | These are the ports you have configured in the Link Aggregation screen to be in the |
| trunk group. |
|
|
Synchronized | These are the ports that are currently transmitting data as one logical link in this trunk |
Ports | group. |
|
|
1.Port Priority and Port Number are 0 as it is the aggregator ID for the trunk group, not the individual port.
116 |
| |
| ||
|
|
|