Chapter 19 Multicast
Figure 64 Advanced Application > Multicast > Multicast Setting
The following table describes the labels in this screen.
Table 41 Advanced Application > Multicast > Multicast Setting
LABEL | DESCRIPTION |
IGMP Snooping | Use these settings to configure IGMP Snooping. |
|
|
Active | Select Active to enable IGMP Snooping to forward group multicast traffic only to |
| ports that are members of that group. |
|
|
Host Timeout | Specify the time (from 1 to 16,711,450) in seconds that elapses before the Switch |
| removes an IGMP group membership entry if it does not receive report messages |
| from the port. |
|
|
Leave Timeout | Enter an IGMP leave timeout value (from 1 to 16,711,450) in seconds. This |
| defines how many seconds the Switch waits for an IGMP report before removing |
| an IGMP snooping membership entry when an IGMP leave message is received |
| from a host. |
|
|
802.1p Priority | Select a priority level |
| IGMP control packets. Otherwise, select |
|
|
IGMP Filtering | Select Active to enable IGMP filtering to control which IGMP groups a subscriber |
| on a port can join. |
| Note: If you enable IGMP filtering, you must create and assign |
| IGMP filtering profiles for the ports that you want to allow to |
| join multicast groups. |
|
|
Unknown | Specify the action to perform when the Switch receives an unknown multicast |
Multicast Frame | frame. Select Drop to discard the frame(s). Select Flooding to send the frame(s) |
| to all ports. |
| 133 |
|
|