Chapter 27 Access Control

The following table describes the labels in this screen.

Table 82 Management > Access Control > SNMP > Trap Group

LABEL

DESCRIPTION

Trap Destination

Select one of your configured trap destination IP addresses. These are the IP

IP

addresses of the SNMP managers. You must first configure a trap destination IP

 

address in the SNMP Setting screen.

 

Use the rest of the screen to select which traps the Switch sends to that SNMP

 

manager.

 

 

Type

Select the categories of SNMP traps that the Switch is to send to the SNMP

 

manager.

 

 

Options

Select the individual SNMP traps that the Switch is to send to the SNMP station.

 

See Section 27.3.3 on page 199 for individual trap descriptions.

 

The traps are grouped by category. Selecting a category automatically selects all of

 

the category’s traps. Clear the check boxes for individual traps that you do not want

 

the Switch to send to the SNMP station. Clearing a category’s check box

 

automatically clears all of the category’s trap check boxes (the Switch only sends

 

traps from selected categories).

 

 

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch

 

loses these changes if it is turned off or loses power, so use the Save link on the top

 

navigation panel to save your changes to the non-volatile memory when you are

 

done configuring.

 

 

Cancel

Click Cancel to begin configuring this screen afresh.

 

 

27.3.6 Setting Up Login Accounts

Up to five people (one administrator and four non-administrators) may access the Switch via web configurator at any one time.

An administrator is someone who can both view and configure Switch changes. The username for the Administrator is always admin. The default administrator password is 1234.

"It is highly recommended that you change the default administrator password (1234).

A non-administrator (username is something other than admin) is someone who can view but not configure Switch settings.

Click Management > Access Control > Logins to view the screen as shown.

 

205

ES-2024 Series User’s Guide