Chapter 22 Loop Guard
Table 62 | Advanced Application > Loop Guard (continued) | |
LABEL |
| DESCRIPTION |
Active |
| Select this check box to enable the loop guard feature on this port. The Switch sends |
|
| probe packets from this port to check if the Switch it is connected to is in loop state. |
|
| If the Switch that this port is connected is in loop state the Switch will shut down this |
|
| port. |
|
| Clear this check box to disable the loop guard feature. |
|
|
|
Apply |
| Click Apply to save your changes to the Switch’s |
|
| loses these changes if it is turned off or loses power, so use the Save link on the top |
|
| navigation panel to save your changes to the |
|
| done configuring. |
|
|
|
Cancel |
| Click Cancel to begin configuring this screen afresh. |
|
|
|
172 |
| |
| ||
|
|
|