10
Filtering
This chapter discusses MAC address port filtering.
10.1 Configure a Filtering Rule
Filtering means sifting traffic going through the Switch based on the MAC addresses and VLAN group (ID).
Click Advanced Application > Filtering in the navigation panel to display the screen as shown next.
Figure 39 Advanced Application > Filtering
The following table describes the related labels in this screen.
Table 20 Advanced Application > Filtering
LABEL | DESCRIPTION |
Active | Make sure to select this check box to activate your rule. You may temporarily deactivate |
| a rule without deleting it by deselecting this check box. |
|
|
Name | Type a descriptive name (up to 32 English keyboard characters) for this rule. This is for |
| identification only. |
|
|
MAC | Type a MAC address in valid MAC address format, that is, six hexadecimal character |
| pairs. |
|
|
VID | Type the VLAN group identification number. |
|
|
Add | Click Add to save your changes to the Switch’s |
| these changes if it is turned off or loses power, so use the Save link on the top |
| navigation panel to save your changes to the |
| configuring. |
|
|
| 93 |
|
|