Chapter 14 IP Screen
These parameters should work for the majority of installations.
14.2 The IP Screen
Use this screen to configure the IP address for your NWA. Click IP to display the following screen.
Figure 105 IP Setup
The following table describes the labels in this screen.
Table 49 IP Setup
LABEL | DESCRIPTION |
IP Address Assignment | |
|
|
Get automatically | Select this option if your NWA is using a dynamically assigned IP |
from DHCP | address from a DHCP server each time. |
| Note: You must know the IP address assigned to the NWA (by |
| the DHCP server) to access the NWA again. |
|
|
Use fixed IP address | Select this option if your NWA is using a static IP address. When |
| you select this option, fill in the fields below. |
|
|
IP Address | Enter the IP address of your NWA in dotted decimal notation. |
| Note: If you change the NWA's IP address, you must use the |
| new IP address if you want to access the web |
| configurator again. |
|
|
IP Subnet Mask | Type the subnet mask. |
|
|
Gateway IP Address | Type the IP address of the gateway. The gateway is an immediate |
| neighbor of your NWA that will forward the packet to the |
| destination. On the LAN, the gateway must be a router on the |
| same segment as your NWA; over the WAN, the gateway must be |
| the IP address of one of the remote nodes. |
|
|
Apply | Click Apply to save your changes. |
|
|
Reset | Click Reset to begin configuring this screen afresh. |
184 |
| |
| ||
|
|
|