Chapter 4 Status Screens
4.2.1 System Statistics Screen
Use this screen to view diagnostic information about the NWA. Click Show Statistics in the Status screen. The following screen pops up.
Note: The Poll Interval field is configurable. The fields in this screen vary according to the current wireless mode of each WLAN adaptor.
Figure 55 System Status: Show Statistics
The following table describes the labels in this screen.
Table 9 System Status: Show Statistics
LABEL | DESCRIPTION |
Port | This is the Ethernet port (LAN) or wireless LAN adaptor (WLAN). |
|
|
Status | This shows the port speed and duplex setting if you are using |
| Ethernet encapsulation for the Ethernet port. Ethernet port |
| connections can be in |
| refers to a device's ability to send and receive simultaneously, while |
| |
| time. The Ethernet port must use the same speed or duplex mode |
| setting as the peer Ethernet port in order to connect. |
| This shows the transmission speed only for the wireless adaptors. |
|
|
TxPkts | This is the number of transmitted packets on this port. |
|
|
RxPkts | This is the number of received packets on this port. |
|
|
Collisions | This is the number of collisions on this port. |
|
|
Tx B/s | This shows the transmission speed in bytes per second on this port. |
|
|
Rx B/s | This shows the reception speed in bytes per second on this port. |
|
|
Up Time | This is total amount of time the line has been up. |
|
|
Poll Interval(s) | Enter the time interval for refreshing statistics. |
|
|
Set Interval | Click this button to apply the new poll interval you entered above. |
|
|
Stop | Click this button to stop refreshing statistics. |
|
|
86 |
| |
| ||
|
|
|