Chapter 1 Introducing the NWA
1.2.5 Pre-Configured SSID Profiles
The NWA has two
•VoIP_SSID. This profile is intended for use by wireless clients requiring the highest QoS level for VoIP telephony and other applications requiring low latency. The QoS level of this profile is not
•Guest_SSID. This profile is intended for use by visitors and others who require access to certain resources on the network (an Internet gateway or a network printer, for example) but must not have access to the rest of the network. Layer 2 isolation is enabled (see Section on page 178), and QoS is set to NONE.
1.2.6Configuring Dual WLAN Adaptors
The NWA is equipped with dual wireless adaptors. This means you can configure two different wireless networks to operate simultaneously.
In the following example, the NWA (Z) uses WLAN1 in Access Point mode to allow IEEE 802.11b and IEEE 802.11g clients to access the wired network, and WLAN2 in AP+Bridge mode to allow an IEEE 802.11a AP to communicate with the wired network.
Figure 9 Dual WLAN Adaptors Example
Z
WLAN2 |
|
| WLAN1 |
|
| ||
|
| ||
|
| 802.11b/g | |
802.11a |
|
| Access Point |
AP + Bridge | Internet | ||
|
30 |
| |
| ||
|
|
|