Chapter 8 Wireless Configuration
Table 23 Wireless: Access Point
LABEL | DESCRIPTION |
SSID Profile | The SSID (Service Set IDentifier) identifies the Service Set with which |
| a wireless station is associated. Wireless stations associating to the |
| access point (AP) must have the same SSID. Select an SSID Profile |
| from the |
| Configure SSID profiles in the SSID screen (see Section 9.2 on page |
| 147 for information on configuring SSID). |
| If you are configuring the NWA from a computer connected to the |
| wireless LAN and you change the NWA’s SSID or security settings, |
| you will lose your wireless connection when you press Apply to |
| confirm. You must then change the wireless settings of your |
| computer to match the NWA’s new settings. |
|
|
Rates | This section controls the data rates permitted for clients. |
Configuration | For each Rate, select an option from the Configuration list. The |
| |
| options are: |
| • Basic (1~11 Mbps only): Clients can always connect to the access |
| point at this speed. |
| • Optional: Clients can connect to the access point at this speed, |
| when permitted to do so by the AP. |
| • Disabled: Clients cannot connect to the access point at this |
| speed. |
|
|
Enable Antenna | Select this to use antenna diversity. Antenna diversity uses multiple |
Diversity | antennas to reduce signal interference. |
|
|
Enable Breathing | Select this box to disable the WLAN LED (light). Clear this box to |
LED | enable the WLAN LED. |
|
|
Enable Spanning | (R)STP (Section 8.4.1 on page 139) detects and breaks network loops |
Tree Control | and provides backup links between switches, bridges or routers. It |
(STP) | allows a bridge to interact with other (R)STP |
| your network to ensure that only one path exists between any two |
| stations on the network. Select the check box to activate STP on the |
| NWA. |
|
|
Enable Roaming | Roaming allows wireless stations to switch from one access point to |
| another as they move from one coverage area to another. Select this |
| checkbox to enable roaming on the NWA if you have two or more |
| NWAs on the same subnet. |
| Note: All APs on the same subnet and the wireless stations must |
| have the same SSID to allow roaming. |
|
|
Apply | Click Apply to save your changes. |
|
|
Reset | Click Reset to begin configuring this screen afresh. |
8.3.2 Bridge / Repeater Mode
Use this screen to have the NWA act as a wireless network bridge / repeater and establish wireless links with other APs. You need to know the MAC address of the peer device, which also must be in bridge / repeater mode.
126 |
| |
| ||
|
|
|