ZyXEL Communications P-1100 manual IP Policy Routing 13-5

	Prestige 1100 Internet Access Router
	Table 13-2 IP Routing Policy
Field	Description
Policy Set Name	This is the name of the policy set assigned in Menu 25 - IP Routing Policy
	Setup.
Active	Press the [SPACEBAR] to select [Yes] to activate the policy.
Criteria
IP Protocol	IP layer 4 protocol, e.g., UDP, TCP, ICMP, etc.
Type of Service	Prioritize incoming network traffic by choosing from [Don’t Care] / [Normal] /
	[Min Delay] / [Max Thruput] / [Max Reliability].
Packet Length	Enter the length of incoming packets (in bytes). The operators in the [Len
	Comp] (next) apply to packets of this length.
Len Comp	Press the [SPACEBAR] to choose from [Equal] / [Not Equal] / [Less] / [Greater] /
	[Less or Equal] / Greater or Equal].
Precedence	Precedence value of the incoming packet. Values range from [0] to [7] or [Don’t
	Care].
Source:
addr start= /	Source IP address range from start to end.
end=
port start= /	Source port number range from start to end; applicable only for TCP/UDP.
end=
Destination:
addr start= /	Destination IP address range from start to end.
end=
port start= /	Destination port number range from start to end; applicable only for TCP/UDP.
end=
Action=	Specifies whether action should be taken on criteria [Matched] or [Not
	Matched].
Gateway addr	Defines the outgoing gateway address. The gateway must be on the same
	subnet as the Prestige if it’s on the LAN, otherwise, the gateway must be the IP
	address of a remote node. The default gateway is specified as 0.0.0.0.
Log	Press the [SPACEBAR] to select [Yes] to make an entry in the system log when
	a policy is executed.
Type of Service	Set the new TOS value of the outgoing packet. Choose from Prioritize incoming
	network traffic by choosing from [No Change] / [Normal] / [Min Delay] / [Max
	Thruput] / [Max Reliability].

Precedence

Set the new precedence value of the outgoing packet. Values range from [0] to [7] or [No Change].

IP Policy Routing 13-5