Prestige 1100 Internet Access Router

Chapter 4: Remote Node Configuration for LAN to LAN

A remote node is required for placing calls to a remote gateway. A remote node represents both the gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up Internet access, you are actually configuring the remote node.

In this chapter, we will discuss the parameters that are protocol independent. The protocol-dependent configuration will be covered in subsequent chapters.

This section describes the protocol-independent parameters for a remote node.

4.1Leased Line Remote Node Profile

To configure a remote node, enter 11 to select Menu 11.1 - Remote Node Setup.

 

Menu 11.1 - Remote Node Profile

 

Rem Node Name=

?

Route= IP

 

Active= Yes

 

Bridge= No

 

 

 

Edit PPP Options= No

Incoming:

 

Rem IP Addr= ?

 

Rem Login= ?

 

Edit IP/IPX/Bridge=

No

Rem Password=

********

Input Filter Sets:

 

 

 

 

Outgoing:

 

Protocol filters

=

My Login= ?

 

Device filters =

 

My Password= ********

Output Filter Sets=

Authen= CHAP/PAP

Protocol filters

=

 

 

Device filters =

 

Press ENTER to CONFIRM or ESC to CANCEL:

Press Space Bar to Toggle.

Figure 4-1 Menu 11.1 - Remote Node Profile for Leased Lines

The following table contains the instructions on how to configure the Remote Node Menu for leased lines.

Remote Node Configuration

4-1

Page 47
Image 47
ZyXEL Communications P-1100 manual Leased Line Remote Node Profile, Menu 11.1 Remote Node Profile for Leased Lines