ZyXEL Communications P-1100 manual Remote Node Setup, Menu 11.3- Remote Node TCP/IP Options

Prestige 1100 Internet Access Router

5.2Remote Node Setup

Follow the procedure in the Remote Node Configuration Chapter to configure the protocol-independent parameters in Menu 11 - Remote Node Profile. For the TCP/IP parameters, follow the instructions below.

Follow the steps below to edit Menu 11.3 - Remote Node Network Layer Options shown in Figure 5-2:

Step 1. In Menu 11.1, make sure [IP] is among the protocols in the Route field. (The Route field should display Route = IP or Route = IP + IPX.)

Step 2. Move the cursor to the [Edit IP/IPX/Bridge] field, then press the space bar to toggle and set the value to [Yes], and press [ENTER] to edit Menu 11.3 - Network Layer Options.

Menu 11.3 - Remote Node Network Layer Options

IP Options:	IPX Options:
Rem IP Addr: 0.0.0.0	Rem LAN Net #= N/A
Rem Subnet Mask= 0.0.0.0	My WAN Net #= N/A
My WAN Addr= 0.0.0.0	Hop Count= N/A
Single User Account= No	Tick	Count= N/A
	W/D	Spoofing(min)= N/A
Metric= 2	SAP/RIP Timeout(min)= N/A
Private= No
RIP Direction= Both	Bridge Options:
Version= RIP-2B	Ethernet Addr Timeout(min)= N/A
Multicast = IGMP-v2
IP Policies=

Enter here to CONFIRM or ESC to CANCEL:

Figure 5-2 Menu 11.3- Remote Node TCP/IP Options

5-2 Remote Node TCP/IP Configuration