
Prestige 1100 Internet Access Router
Menu 21.1.1 - TCP/IP Filter Rule
Filter #: | 1,1 |
|
Filter Type= TCP/IP Filter Rule | ||
Active= Yes |
| |
IP Protocol= 6 | IP Source Route= No | |
Destination: IP Addr= 0.0.0.0 | ||
| IP Mask= 0.0.0.0 | |
| Port #= 137 | |
| Port # Comp= Equal | |
Source: IP Addr= 0.0.0.0 | ||
| IP Mask= 0.0.0.0 | |
| Port #= 0 | |
| Port # Comp= None | |
TCP Estab= No |
| |
More= No |
| Log= None |
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Figure 8-5 Menu 21.1.1 - TCP/IP Filter Rule
The following table describes how to configure your TCP/IP filter rule.
Table 8-5 TCP/IP Filter Rule Menu Fields
Field | Description | Option |
|
|
|
Filter # | This is the filter set, filter rule |
|
| the second filter set and the third filter rule of that set. |
|
|
|
|
Filter Type | Use the space bar to toggle between types of rules. | [Device Filter Rule] / |
| Parameters displayed below each type will be different. | [TCP/IP Filter Rule] / |
|
| [IPX Filter Rule] |
|
|
|
Active | This field activates/deactivates the filter rule. | [Yes]/[No] |
|
|
|
IP Protocol | Protocol refers to the upper layer protocol, e.g., TCP is 6, | |
| UDP is 17 and ICMP is 1. This value must be between 0 and |
|
| 255. Enter 0 if IP protocol is don’t care. |
|
|
|
|
IP Source | If Yes, the rule applies to packet with IP source route option; | [Yes]/[No] |
Route | else the packet must not have source route option. The |
|
| majority of IP packets do not have source route. |
|
|
|
|
Destination: IP | Enter the destination IP Address of the packet you wish to | IP address |
Addr | filter. This field is a |
|
|
|
|
Destination: IP | Enter the IP subnet mask to apply to the Destination: IP Addr. | Subnet mask |
Mask | To filter a single host, enter 255.255.255.255 as the mask. |
|
|
|
|
Filter Configuration |