ZyXEL Communications U-336R/RE manual Modem will wait for DC2 at the beginning of every

Command	Function
	modem will wait for DC2 at the beginning of every
	page. The DTE software should detect the page
	separator RTC and then sends the DC2 to receive
	the next page of fax data. This mode is used with a
	BBS receiving faxes.
#B2	This mode is for the polling feature of the modem.
	In this mode, the modem will send a polling signal
	to the remote fax device to ask to receive a fax from
	the remote fax device. The received fax data will be
	sent to the DTE continuously following the
	connection message.
#B3	Displays the ring cadence.
Parameter Setting
Command	Function
#V0	Set to normal vertical resolution.
#V1	Set to high vertical resolution.
#T0	Set to one dimensional coding scheme.
#T1	Set to two dimensional coding scheme.
#R0	Set recording width: 1728 picture elements along a
	scan line length of 215 mm.
#R1	Set recording width: 2048 picture elements along a
	scan line length of 255 mm.
#R2	Set recording width: 2432 picture elements along a
	scan line length of 303 mm.
#L0	Set maximum recording length: A4 (297 mm ).
#L1	Set maximum recording length: B4 ( 364 mm ).
#L2	Set maximum recording length: unlimited.
#C0	Set minimum scan line time capability of the
	receiver: 20 ms at 3.85 line/mm, T(7.7)=T(3.85).
#C1	Set minimum scan line time capability of the
	receiver: 5 ms at 3.85 line/mm, T(7.7)=T(3.85).

Fax Operation 71