Ryobi RY28140, RY28120 manuel dutilisation Your Warranty Rights and Obligations

Page 20

WARRANTY

TECHTRONIC INDUSTRIES NORTH AMERICA, INC., CALIFORNIA AND FEDERAL EMISSION CONTROL WARRANTY STATEMENT

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Techtronic Industries North America, Inc., are pleased to explain the Emissions Control System Warranty on your new 2013/2014 small off-road engine. In California, new equipment that uses small off-road engines must be designed, built, and equipped to meet the state’s stringent anti-smog standards. In other states, new small off-road engines must be designed, built, and equipped at the time of sale to meet the U.S. EPA regulations for small off-road engines. The small off-road engine must be free from defects in materials and workmanship which cause it to fail to conform with U.S. EPA standards for the first three years of engine use from the date of sale to the ultimate purchaser. Techtronic Industries North America, Inc., must warrant the emission control system on your small off-road engine for the period of time listed above provided there has been no abuse, neglect, or improper maintenance of your small off-road engine.

Your emission control system may include parts such as the carbure- tor or fuel injection system, the ignition system, catalytic converters, fuel tanks, valves, filters, clamps, connectors, and other associated components. Also included may be hoses, belts and connectors, and other emission-related assemblies.

Where a warrantable condition exists, Techtronic Industries North America, Inc., will repair your small off-road engine at no cost to you, including diagnosis, parts, and labor.

MANUFACTURER’S WARRANTY COVERAGE

This 1995 and later small off-road emissions control system is war- ranted for three years. If any ­emission-related part on your engine is defective, the part will be repaired or replaced by Techtronic Industries North America, Inc.

OWNER’S WARRANTY RESPONSIBILITIES

(a)As the small off-road engine owner, you are responsible for the performance of the required maintenance listed in your operator’s manual. Techtronic Industries North America, Inc., recommends that you retain all receipts covering maintenance on your small off-road engine, but Techtronic Industries North America, Inc., cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance.

(b)As the small off-road engine owner, you should be aware, however, that Techtronic Industries North America, Inc., may deny you warranty coverage if your small off-road engine or a part has failed due to abuse, neglect, improper maintenance, or unapproved modifications.

(c)You are responsible for presenting your small off-road engine to an authorized service dealer as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and respon- sibilities, you should contact a Techtronic Industries North America, Inc., Customer Representative at 1-800-860-4050.

DEFECT WARRANTY COVERAGE REQUIREMENTS

(a)The warranty period begins on the date the engine or equipment is delivered to an ultimate purchaser.

(b)General Emissions Warranty Coverage. Techtronic Industries North America, Inc., warrants to the ultimate purchaser and each subsequent purchaser that your small off-road engine is designed, built, and equipped at the time of sale to conform with all applicable regulations adopted by the California Air Resources Board or the United States Environmental Protection Agency; and that it is free from defects in materials and workmanship which cause the engine to fail to conform with applicable regulations for a period of three years from the date the small off-road engine is purchased by the initial purchaser. Any

replacement­part or service that is equivalent in performance and durability may be used in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of Techtronic Industries North America, Inc.

(c)The warranty on emissions-related parts will be interpreted as follows: Any warranted part that is not scheduled for replacement as required in the Maintenance Schedule is warranted for three years. If any such part (including any part that is scheduled only for regular in- spection) fails during the period of warranty coverage, it will be repaired or replaced at any RYOBI® Authorized Service Center at no charge. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period. A statement to the effect of “repair or replace as necessary” would not reduce the period of warranty coverage. Any warranted part that is scheduled for replacement as required maintenance in the Maintenance Schedule is warranted for the period of time prior to the first scheduled replacement point for that part. Any such part repaired or replaced under warranty is warranted for the remainder of the period prior to the first scheduled replace- ment point, and will be repaired or replaced at any RYOBI® Authorized Service Center for no charge until that replacement point is reached.

Techtronic Industries North America, Inc., shall remedy warranty de- fects at any authorized RYOBI® Authorized Service Center, including any distribution center that may be franchised to service the subject engines. Any diagnostic work done at a RYOBI® Authorized Service Center shall be free of charge to the owner if such work determines that a warranted part is defective. Any manufacturer-approved or equiva- lent replacement part may be used for any warranty maintenance or repairs on emission-related parts, and must be provided free of charge to the owner if the part is still under warranty. Techtronic Industries North America, Inc., is liable for damages to other engine components caused by the failure of a warranted part still under warranty.

Add-on or modified parts that are not exempted by the California Air Resource Board may not be used. The use of any non-exempted add- on or modified parts will be grounds for disallowing a warranty claim. Techtronic Industries North America, Inc., will not be liable to warrant failures of warranted parts caused by the use of a non-exempted add-on or modified part.

The Emission Parts List specifically defines the emission-related war- ranted parts. Techtronic Industries North America, Inc., will provide any documents that describe its warranty procedures or policies within five days upon request by the California Air Resources Board.

EMISSIONS PARTS LIST

(1)Fuel Metering System

(i)Carburetor and internal parts (and/or pressure regulator or fuel injection system).

(ii)Fuel Tank.

(iii)Fuel Hose.

(iv)Fuel Cap (EPA only)

(2)Air Induction System

(i)Intake manifold (only 4-stroke engines).

(ii)Air filter, if applicable.

(3)Ignition System

(i)Spark plugs.

(ii)Magneto or electronic ignition system.

(4)Catalyst or Thermal Reactor System

(i)Catalytic converter (only 2-stroke engines).

(5)Miscellaneous

(i)Belts (only 4-stroke engines).

Techtronic Industries North America, Inc., will furnish with each new engine written instructions for its maintenance and use by the owner.

16 — English

Image 20
Contents Save this Manual for Future Reference Toutes LES Versions Todas LAS VersionesPage SS26 Posición Correcta Para EL Manejo DE LA Herramienta Eyelet œillet, ojillo Table of Contents IntroductionGeneral Safety Rules Read ALL InstructionsSpecific Safety Rules Symbol Name Explanation SymbolsSymbol Signal Meaning Features AssemblyInstalling the Power Head to the Attachment Removing the Attachment from the Power HeadAttaching the Storage Hanger Attaching the Front HandleFueling and Refueling the Trimmer OperationTo Attach the Straight Shaft Grass Deflector SS26 Oxygenated Fuels Starting and StoppingOperating the Trimmer Cutting TipsGrass Deflector Line Trimming CUT-OFF Blade Advancing String Using the REEL-EASYTAP Advance SystemAdvancing the String Manually Maintenance General MaintenanceSpool Replacement REEL-EASYTAP ADVANCE­ System Line ReplacementIdle Speed Adjustment Cleaning the AIR FilterSpark Plug Replacement Fuel CAP, TANK, and LinesMaintenance Schedule This Product WAS Manufactured with a Catalyst MufflerAIR Filter Assy Carburetor AssySpeed. See Figure TroubleshootingGap. Refer to Spark Plug Replacement earlier Warranty Limited Warranty StatementYour Warranty Rights and Obligations English Lire Toutes LES Instructions Règles DE Sécurité GénéralesAvertissement Règles DE Sécurité Particulières Symboles Symbole NOM ExplicationCaractéristiques AssemblageInstallation DU BLOC-MOTEUR SUR L’ACCESSOIRE Retrait DE L’ACCESSOIRE DU Bloc MoteurInstallation DE L’ANNEAU DE Suspension Installation DE LA Poignée AvantUtilisation Approvisionnement EN Carburant AvertissementMélange DE Carburant Lubrifiant 2 Temps DE Haute Qualité EssencelubrifiantCarburants Oxygénés Démarrage ET ArrêtUtilisation DU TAILLE-BORDURES Voir les figures 7 àVoir les figures 10 à Conseils DE CoupeAvance Manuelle DE LA Ligne DE Coupe Remplacement DE Ligne EntretienEntretien Général Voir les figures 16 àRemplacement DE LA Bougie Réglage DU RalentiNettoyage DU Filtre À AIR Remisage LE ProduitProgramme D’ENTRETIEN ’AIDE?Dépannage Nettoyage du filtre à air écran, plus haut dans ce manuelGarantie Énoncé DE LA Garantie LimitéeResponsabilités DU Propriétaire Dans LE Cadre DE LA Garantie Français LEA Todas LAS Instrucciones Reglas DE Seguridad GeneralesAdvertencia Reglas DE Seguridad Específicas Symbolo Nombre Explicatión SímbolosSímbolo Señal Significado Peligro PrecauciónCaracterísticas ArmadoInstalación DEL Cabezal Motor EN EL Aditamento Montaje DE LA ASA DE ALMACENAMIENTOMontaje DEL Mango Delantero Montaje DEL Deflector DE Pasto AdvertenciaLlenado DEL Tanque FuncionamientoMezcla DE Combustible Combustibles Oxigenados Arranque Y ApagadoManejo DE LA Recortadora Vea las figuras 7 aSugerencias Para Cortar Avance Manualmente EL HiloCuchilla DE Corte DEL Hilo EN EL Deflector DE Hierba Vea las figuras 10 aMantenimiento Mantenimiento GeneralReabastecimiento DEL Hilo Vea las figuras 14 aAjuste DE LA Marcha Lenta Reemplazo DE LA BujíaLimpieza DEL Filtro DE Aire Almacenamiento DE LA ProductoOperación DEL Motor a Altitudes Elevadas Este Producto SE Fabricó CON UN Silenciador CatalíticoPrograma DE Mantenimiento 4050Solución DE Problemas El motor no arranca No hay chispaGarantía Declaración DE LA Garantía LimitadaIv Tapa del combustible EPA solamente Notas ALL Versions / Toutes LES Versions / Todas LAS Versiones Manuel D’UTILISATION / Manual DEL OperadorCS26 RY28120 SS26 RY28140