Ryobi CS -- RY34420, SS -- RY34440 manuel dutilisation MANUFACTURER’S Warranty Coverage

Page 20

WARRANTY

The following California Air Resources Board (CARB) statement only applies to model numbers required to meet the CARB requirements.

TECHTRONIC INDUSTRIES NORTH AMERICA, INC., LIMITED WARRANTY STATEMENT FOR FEDERAL AND CALIFORNIA EMISSION CONTROL SYSTEMS NON-ROAD AND SMALL OFF-ROAD ENGINES

YOUR WARRANTY RIGHTS AND OBLIGATIONS

The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Techtronic Industries North America, Inc., are pleased to explain the Emissions Control System Warranty on your 2008 model year non-road or small off- road engine. In California, new equipment that uses small off-road engines must be designed, built, and equipped to meet the state’s stringent anti-smog standards. In other states, new 2000 and later model year non-road engines must be designed, built, and equipped at the time of sale to meet the U.S. EPA regulations for small non-road engines. The non-road engine must be free from defects in materials and workmanship which cause it to fail to conform with U.S. EPA standards for the first two years of engine use from the date of sale to the ultimate purchaser. Techtronic Industries North America, Inc., must warrant the emission control system on your non-road or small off-road engine for the period of time listed above provided there has been no abuse, neglect, or improper maintenance of your non-road or small off-road engine.

Your emission control system may include parts such as the carburetor or fuel injection system, the ignition system, catalytic converters, fuel tanks, valves, filters, clamps, connectors, and other associated components. Also included may be hoses, belts and connectors, and other emission-related assemblies.

Where a warrantable condition exists, Techtronic Industries North America, Inc., will repair your non-road or small off-road engine at no cost to you, including diagno- sis, parts, and labor performed at an authorized service center for RYOBI® brand outdoor products.

MANUFACTURER’S WARRANTY COVERAGE:

This product’s emissions control system is warranted for two years. If any emis- sion-related part on your engine is defective, the part will be repaired or replaced by Techtronic Industries North America, Inc., free of charge.

OWNER’S WARRANTY RESPONSIBILITIES

(a)As the non-road or small off-road engine owner, you are responsible for the performance of the required maintenance listed in your operator’s manual. Techtronic Industries North America, Inc., recommends that you retain all re- ceipts covering maintenance on your non-road or small off-road engine, but Techtronic Industries North America, Inc., cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of all scheduled maintenance. Any replacement part or service that is equivalent in performance and durability may be used in non-warranty maintenance or repairs, and shall not reduce the warranty obligations of Techtronic Industries North America, Inc.

(b)As the non-road or small off-road engine owner, you should be aware, however, that Techtronic Industries North America, Inc., may deny you warranty coverage if your non-road or small off-road engine or a part has failed due to abuse, neglect, improper maintenance, or unapproved modifications.

(c)You are responsible for presenting your non-road or small off-road engine to an authorized service dealer as soon as a problem exists. The warranty repairs should be completed in a reasonable amount of time, not to exceed 30 days.

If you have any questions regarding your warranty rights and responsibilities, you should contact a Techtronic Industries North America, Inc., Customer Representa- tive at 1-800-860-4050.

DEFECT WARRANTY COVERAGE REQUIREMENTS:

(a)The warranty period begins on the date the engine or equipment is delivered to an ultimate purchaser.

(b)General Emissions Warranty Coverage. Techtronic Industries North America, Inc., warrants to the ultimate purchaser and each subsequent purchaser that your non-road or small off-road engine is designed, built, and equipped at the time of sale to conform with all applicable regulations adopted by the California Air Resources Board or the United States Environmental Protection Agency; and that it is free from defects in materials and workmanship which cause the engine to fail to conform with applicable regulations for a period of two years from the date the non-road or small off-road engine is purchased by the initial purchaser.

(c)The warranty on emissions-related parts will be interpreted as follows: Any warranted part that is not scheduled for replacement as required in the Emissions Maintenance Schedule and Warranty Parts List set forth below is warranted for two years. If any such part (including any part that is scheduled only for regular inspection) fails during the period of warranty coverage, it will be repaired or replaced at any RYOBI® Authorized Service Center at no charge. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period. A statement to the effect of “repair or replace as necessary” would not reduce the period of war- ranty coverage. Any warranted part that is scheduled for replacement as required maintenance in the Emissions Maintenance Schedule and Warranty Parts List is warranted for the period of time prior to the first scheduled replacement point for that part. Any such part repaired or replaced under warranty is warranted for the remainder of the period prior to the first scheduled replacement point, and will be repaired or replaced at any RYOBI® Authorized Service Center for no charge until that replacement point is reached.

Techtronic Industries North America, Inc., shall remedy warranty defects at any authorized RYOBI® Authorized Service Center, including any distribution center that may be franchised to service the subject engines. Any diagnostic work done at a RYOBI® Authorized Service Center shall be free of charge to the owner if such work determines that a warranted part is defective. Any manufacturer-approved or equivalent replacement part may be used for any warranty maintenance or repairs on emission-related parts, and must be provided free of charge to the owner if the part is still under warranty. Techtronic Industries North America, Inc., is liable for damages to other engine components caused by the failure of a warranted part still under warranty.

Add-on or modified parts that are not exempted by the California Air Resource Board may not be used. The use of any non-exempted add-on or modified parts will be grounds for disallowing a warranty claim. Techtronic Industries North America, Inc., will not be liable to warrant failures of warranted parts caused by the use of a non- exempted add-on or modified part.

The California Air Resources Board’s Emission Warranty Parts List specifically defines the emission-related warranted parts. (EPA’s regulations do not include a parts list, but the EPA considers emission-related warranted parts to include all the parts listed below.) Techtronic Industries North America, Inc., will provide any documents that describe its warranty procedures or policies within five days upon request by the California Air Resources Board.

EMISSIONS PARTS LIST

Emissions parts vary from product to product. Your emissions control system warranty applies to any of the following components that may be included on your product:

(1)Fuel Metering System

(i)Carburetor and internal parts (and/or pressure regulator or fuel injection system).

(ii)Air/fuel ratio feedback and control system.

(iii)Cold start enrichment system.

(iv)Fuel Tank.

(2)Air Induction System

(i)Controlled hot air intake system.

(ii)Intake manifold.

(iii)Air filter.

(3)Ignition System

(i)Spark Plugs.

(ii)Magneto or electronic ignition system.

(iii)Spark advance/retard system.

(4)Exhaust Gas Recirculation (EGR) System

(i)EGR valve body and carburetor spacer, if applicable.

(ii)EGR rate feedback and control system.

(5)Air Injection System

(i)Air pump or pulse valve.

(ii)Valves affecting distribution of flow.

(iii)Distribution manifold.

(6)Catalyst or Thermal Reactor System

(i)Catalytic converter.

(ii)Thermal reactor.

(iii)Exhaust manifold.

(7)Particulate Controls

(i)Traps, filters, precipitators, and any other device used to capture particulate emissions.

(8)Miscellaneous Items Used in Above Systems

(i)Electronic controls.

(ii)Vacuum, temperature, and time sensitive valves and switches.

(iii)Hoses, belts, connectors, and assemblies.

Techtronic Industries North America, Inc., will furnish with each new engine written instructions for its maintenance and use by the owner.

The Emissions Compliance Period referred to on the Emissions Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal emission requirements. Category C=50 hours, B=125 hours, and A=300 hours.

16 — English

Image 20
Contents RY34440 Save this Manual for Future ReferenceC430 RY34420 C430 S430 Knob bouton, perillaIii Introduzca LOS Hilos a Través DE LAS Ranuras Hasta QUE Screw vis, tornillo Table of Contents General Safety Rules Read all instructionsSymbol Name Specific Safety RulesSymbols Features Attaching the Storage Hanger AssemblyUnpacking Operation Oxygenated FuelsADDING/checking engine lubricant Operating the TrimmerTo Advance the Cutting line reel easy string head To add engine lubricantStarting and Stopping Cutting TipsGrass Deflector line Trimming CUT-OFF Blade Maintenance General MaintenanceCleaning the Exhaust Port and Muffler Spark Arrestor Fuel CAPStoring the Product Adjusting valve-to-rocker arm clearance­When storing 1 month or longer Ing Air Filter Screen earlier in this TroubleshootingProblem Possible Cause Solution 4050 WarrantySee Adding/Checking Engine Limited Warranty Statement MANUFACTURER’S Warranty Coverage English Règles DE Sécurité Générales Lire Toutes LES InstructionsRègles DE Sécurité Particulières SymbolesSymbole Nom Caractéristiques Installation DU BLOC-MOTEUR SUR L’ACCESSOIRE Retrait DE L’ACCESSOIRE DU Bloc MoteurInstallation DE L’ANNEAU DE Suspension DéballageAssemblage UtilisationAJOUT/VÉRIFICATION DE Lubrifiant Utilisation DU TAILLE-BORDURESPour ajouter de l’huile à moteur Pour vérifier le niveau d’huile du moteurConseils DE Coupe Démarrage ET ArrêtVoir les figures 9 et Voir les figures 12 àInstallation DE LA Tête DE Coupe Reel Easy Installation DU FIL Dans LA Tête DE Coupe Reel EasyInstallation DE LA Tête DE Coupe PRO CUT EntretienInstallation DU FIL Dans LA Tête DE Coupe PRO CUT Nettoyage DU Filtre À AIR ÉcranBouchon DU Réservoir Avertissement Changer LE Lubrifiant À MoteurAjuster LE Dégagement Entre LA Soupape ET LE Culbuteur Remisage le produitVoir les figures 25 Remisage 1 mois ou plusLa figure Problème Cause Possible SolutionDépannage Garantie Ajout d’huile à moteur et vérificationÉnoncé DE LA Garantie Limitée Responsabilités DU Propriétaire Dans LE Cadre DE LA Garantie Français Lea todas las instrucciones Reglas DE Seguridad GeneralesAdvertencia Reglas DE Seguridad Específicas SímbolosCaracterísticas Armado DesempaquetadoInstalación DEL Cabezal Motor EN EL Aditamento Montaje DE LA ASA DE ALMACENAMIENTOFuncionamiento Montaje DEL Mango DelanteroMontaje DEL Deflector DE Pasto Advertencia Para montar el deflector de pasto del eje curvo C430Para Avanzar EL Hilo DE Corte Cabezal DEL Hilo de reel EasY PrecauciónManejo DE LA Recortadora Sugerencias Para Cortar Cuchilla DE Corte DEL Hilo EN EL Deflector DE HierbaArranque Y Apagado Vea las figuras 9 yMantenimiento Mantenimiento GeneralInstalación DEL Cabezal DEL Hilo Reel Easy Instalación DEL Hilo EN EL Cabezal DEL Hilo Reel EasyInstalación DEL Hilo EN EL Cabezal DEL Hilo PRO CUT Limpieza DEL Orificio DE Escape Y DEL SilenciadorParachispas Tapa DEL Tanque DE Combustible AdvertenciaAjuste DE LA Apertura DE LA Válvula DEL Balancín Almacenamiento de la productoAbastecimiento y verificación del lubricante para motor Vea las figuras 25Solución DE Problemas Problema Causa Posible SoluciónLa sección Limpieza del filtro de aire Sección Reemplazo de la bujía más arribaEl lubricante para motor en la sección Garantía10w-30. Consulte cómo agregar/verificar Declaración DE LA Garantía Limitada Cobertura DE LA Garantía DEL Fabricante Notas AVERTISSEMENT  Manuel D’UTILISATION / Manual DEL Operador